268954910-Renault-Scenic.pdf

MECHANICAL COMPONENT CONTROLS
Master cylinder: Removal - Refitting
37A
F4R or F9Q or K4J or K4M or K9K or M9R
101711
a Line up the master cylinder with the brake servo so
that the pushrod goes into the master cylinder housing.
WARNING
When refitting the master cylinder, be sure that
the cup is centred in the brake servo.
a Refit the nuts securing the master cylinder to the
brake servo.
a Torque tighten the master cylinder mounting nuts
(50 Nm) on the servo.
a Proceed in the reverse order to removal.
a Torque tighten the brake pipe nuts (17 Nm) on the
master cylinder.
a Bleed the brake circuit (see 30A, General information,
Brake circuit Bleeding, page 30A-2) .
a Connect the battery (see Battery : Removal - Refitting)
(MR 370, 80A, Battery).
37A-4