268954910-Renault-Scenic.pdf
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
STEERING ASSEMBLY<br />
Steering wheel: Removal - Refitting<br />
36A<br />
Essential equipment<br />
diagnostic tool<br />
Tightening torquesm<br />
steering wheel mounting<br />
bolt<br />
44 Nm<br />
IMPORTANT<br />
It is essential to lock the airbag computer using the<br />
diagnostic tool before starting the removal. When<br />
this function is activated, all the trigger lines are<br />
inhibited and the airbag warning light on the instrument<br />
panel is continuously lit (with the ignition on).<br />
Locking the airbag computer also unlocks the electric<br />
steering column lock.<br />
IMPORTANT<br />
It is not permitted to handle the pyrotechnic systems<br />
(airbags and pretensioners) near a source of<br />
heat or flame since there is a risk of these being<br />
triggered.<br />
REMOVAL<br />
a Lock the airbag computer (see Fault finding - Replacement<br />
of components) (MR 372, 88C, Airbag<br />
and pretensioners).<br />
a Disconnect the battery (see Battery : Removal -<br />
Refitting) (MR 370, 80A, Battery).<br />
a Remove the driver's front airbag (see Driver's front<br />
airbag: Removal - Refitting) (MR 370, 88C, Airbags<br />
and seat belt pretensioners).<br />
a Set the wheels straight ahead.<br />
a Disconnect the connectors (depending on equipment<br />
level).<br />
a Remove the steering wheel mounting bolt (1) .<br />
a Remove the steering wheel carefully to avoid disconnecting<br />
the rotary switch connectors.<br />
REFITTING<br />
a The steering wheel bolt must be replaced each time<br />
it is removed.<br />
a Proceed in the reverse order to removal.<br />
103799<br />
WARNING<br />
- Push and pull on the electric power-assisted<br />
steering computer power and signal connectors<br />
to check that they are properly secured<br />
(risk of loss of assistance).<br />
- The column switch should enter the splines<br />
freely (the splines have location notches).<br />
- Do not damage the spline location notches.<br />
a Torque tighten the steering wheel mounting bolt<br />
(44 Nm).<br />
a Refit the driver's front airbag (see Driver's front airbag:<br />
Removal - Refitting) (MR 370, 88C, Airbags<br />
and seat belt pretensioners).<br />
a Connect the battery (see Battery : Removal - Refitting)<br />
(MR 370, 80A, Battery).<br />
36A-21