268954910-Renault-Scenic.pdf

STEERING ASSEMBLY
Intermediate shaft: Removal - Refitting
36A
a Refit the floor carpet.
Note:
Check that the floor carpet reaches under the
accelerator pedal end-stop.
III - FINAL OPERATION.
a Disconnect the battery (see Battery : Removal -
Refitting) (80A, Battery).
a Refit:
103584
- the front left-hand air distribution duct (see Front
air distribution duct: Removal - Refitting) (61A,
Heating system),
-the dashboard lower trim (see Lower section of
dashboard trim: Removal - Refitting) (57A, Interior
equipment),
-the centre front panel (see Centre front panel: Removal
- Refitting) (57A, Interior equipment).
a Connect the battery (see Battery : Removal - Refitting)
(80A, Battery).
a Check that the steering wheel is straight.
a Adjust, if necessary, the geometry of the front axle
(see 30A, General information, Front axle: Adjustment
values, page 30A-14) .
a Perform steering wheel angle sensor programming
(see Fault finding - Configurations and programming)
(36B, Power-assisted steering).
a Connect:
103810
- the start button (3) .
- the RENAULT card reader (4) .
a Connect the battery (see Battery: Removal - Refitting)
(80A, Battery).
a Unlock the steering wheel.
a Tighten to torque:
- the steering column intermediate shaft bolt (30
Nm),
- the universal joint bolt (44 Nm).
36A-20