268954910-Renault-Scenic.pdf

STEERING ASSEMBLY
Intermediate shaft: Removal - Refitting
36A
II - OPERATION FOR REMOVAL OF PART
CONCERNED
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace the universal joint bolt and nut.
a Refit the cam nut on the universal joint.
a Crimp the cover on the universal joint.
II - REFITTING OPERATION FOR PART
CONCERNED
118664
a Remove the bolt (1) from the intermediate shaft side
of the steering column.
a Mark the position of the intermediate shaft on the column.
a Separate the intermediate shaft by pulling it in the direction
of the arrow.
a Lift the floor carpet to access the universal joint.
101354
a Observe the direction of fitting for the universal joint
cam nut.
a Refit the universal joint.
a Refit the universal joint bolt and cam nut.
a Fit on the universal joint bolt without tightening it.
a Lock the cam nut in its housing (on the universal
joint).
a Discard the cover (2) using a hammer (do not keep
it).
a Remove:
- the universal joint bolt (do not keep),
- the universal joint cam nut (do not keep it).
- the intermediate shaft.
104020
36A-18