268954910-Renault-Scenic.pdf

STEERING ASSEMBLY
Steering column: Removal - Refitting
36A
II - REFITTING OPERATION FOR PART
CONCERNED
1 - NSK column
a Clip on:
- the instrument panel lower trim piece,
- the instrument panel upper trim piece.
a
Note:
When replacing an NSK type steering column on
vehicles not equipped with ESP, do not remove
the steering wheel angle sensor located on the
new steering column.
a Refit:
- the steering column,
- the steering column nuts.
a Torque tighten the steering column nuts (21 N.m).
a Clip the steering column rotary switch wiring harness.
a Refit the column lock.
a Connect the column lock connector.
a Refit the column lock bolt.
a Torque tighten the steering column lock bolt (8
N.m).
2 - TRW column
101354
a Respect the direction of fitting for the universal joint
cam bolt and nut.
a Refit the universal joint.
a Refit the cam nut and the fork bolt.
a Finger tighten the cam nut and the yoke bolt.
a Immobilise the cam nut in its housing (on the universal
joint).
a Pretighten the universal joint nut and bolt.
a Refit the steering column.
a Connect the connectors.
a Refit the steering column nuts, starting with the
lower threaded stud the furthest away and finishing
with the upper threaded stud.
a Torque tighten the steering column nuts (21 N.m).
a Clip the steering column rotary switch wiring harness.
a Connect:
- the electric power-assisted steering computer
power connector using a 4 mm wide and 0.5 mm
thick screwdriver,
-the electric power-assisted steering computer signal
connector using a 4 mm wide and 0.5 mm
thick screwdriver.
a Refit the column lock.
a Connect the column lock connector.
a Refit the electric steering column lock bolt.
a Torque tighten the electric steering column lock
bolt (8 N.m).
36A-13