268954910-Renault-Scenic.pdf

STEERING ASSEMBLY
Axial ball joint linkage: Removal - Refitting
36A
EQT LEVEL SPORT
REFITTING
a Adjust the axle assemblies.
WARNING
Program the torque and angle sensor using the
diagnostic tool.
Note:
It is essential to initialise the xenon bulb system
(see MR 364, Electrical equipment, 80C,
Xenon bulbs).
Adjust the headlights.
a Always replace washer (3) with a new one.
101355
a Refit:
- the stop (3) (13 mm thick),
- the axial ball joint (4) (specific length: 230 mm).
a Torque tighten the axial ball joint (80 N.m) using
the tool (Dir. 1305-01).
a Coat the following parts with lithium grease:
- the steering rack,
- the axial ball joint.
a Refit:
- the gaiter,
- the metal clip,
- the new plastic clip, the same as the original fitting,
- the lock nut,
- the ball joint housing.
a Retighten the track rod end housing by the number
of rotations noted during removal.
a Refit the track rod end.
a Tighten to torque:
- the wheel alignment adjusting lock nut (53
N.m),
- the track rod end nut (37 N.m),
- the wheel mounting bolts (130 N.m).
WARNING
Connect the battery, starting with the positive terminal;
carry out the necessary programming (see
80A, Battery, Battery: Removal - Refitting).
a Torque tighten the battery cover bolts (4 N.m).
36A-7