268954910-Renault-Scenic.pdf

GENERAL INFORMATION
Axle assemblies: Check
30A
a Lock the slip plates of the lift.
a Position the vehicle on a lift (see Vehicle: Towing
and lifting) .
a Check the condition of the following components:
- track rods,
- axial ball joint linkages,
- subframe,
- lower arm rubber bushes,
- lower arm ball joints (see 31A, Front axle components,
Front driveshaft lower arm ball joint:
Check, page 31A-25) ,
- shock absorbers,
- tyres,
a Check:
- the tyre size (see 35A, Wheels and tyres, Tyres:
Identification, page 35A-7) ,
-the tyre inflation pressure (see 35A, Wheels and
tyres, Tyre inflation pressure: Identification,
page 35A-10) .
a Put the vehicle in the VODM position (vehicle in running
order) (see 30A, General information, Underbody
height: Adjustment values, page 30A-9) :
- tank full,
- vehicle empty (without luggage, etc.).
a Consult:
- the front axle geometry values (see 30A, General
information, Front axle: Adjustment values,
page 30A-14) ,
-the rear axle geometry values (see 30A, General
information, Rear axle: Adjustment values,
page 30A-18) .
a Refer to the user manual for the geometry tester.
a Check the geometry using the geometry tester.
a If there is an inconsistency between the manufacturer's
values and the measured values:
a Adjust the front axle (see 30A, General information,
Front axle: Adjusting, page 30A-16)
30A-8