268954910-Renault-Scenic.pdf
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
STEERING ASSEMBLY<br />
Axial ball joint linkage: Removal - Refitting<br />
36A<br />
EQT LEVEL E3 PLUS or EQT LEVEL EA1 or EQT LEVEL EA2 or EQT LEVEL EA3 or EQT LEVEL EA4 or EQT<br />
LEVEL EA5 or EQT LEVEL EA6 or EQT LEVEL EAG<br />
Essential special tooling<br />
II - OPERATION FOR REMOVAL OF PART<br />
CONCERNED<br />
Dir. 1306-04<br />
Tool for locking steering rack.<br />
Dir. 1305-01 Tool for removing/refitting 35<br />
mm to 41 mm diameter axial<br />
ball joints.<br />
Tightening torquesm<br />
axial ball joint<br />
80 N.m<br />
REMOVAL<br />
I - REMOVAL PREPARATION OPERATION<br />
a Position the vehicle on a two-post lift (see Vehicle:<br />
Towing and lifting) .<br />
a Remove the front wheel (see 35A, Wheels and tyres,<br />
Wheel: Removal - Refitting, page 35A-1) .<br />
a Remove the track rod (see 36A, Steering assembly,<br />
Track rod: Removal - Refitting, page 36A-3) .<br />
a Remove the steering rack gaiter (see 36A, Steering<br />
assembly, Steering rack gaiter: Removal - Refitting,<br />
page 36A-15) .<br />
a Unlock the steering column.<br />
Note:<br />
a Set up the (Dir. 1306-04) (1) on the steering rack, at<br />
the pinion end.<br />
a Unlock the axial ball joint using tool (Dir. 1305-01)<br />
(2) .<br />
a Remove the axial ball joint.<br />
REFITTING<br />
102206<br />
I - REFITTING PREPARATION OPERATION<br />
a parts always to be replaced: Steering axial ball<br />
joint washer (13,04,02,04)<br />
During this operation, the steering rack must be<br />
in place on the vehicle.<br />
36A-4