268954910-Renault-Scenic.pdf

STEERING ASSEMBLY
Steering rack: Removal - Refitting
36A
Tightening torquesm
II - OPERATION FOR REMOVAL OF PART
CONCERNED
steering box bolts
105 N.m
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair (see Steering: Precautions for repair) .
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the front wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) ,
- the engine undertray bolts,
- the engine undertray,
-the front axle subframe (see 31A, Front axle components,
Front axle sub-frame: Removal - Refitting,
page 31A-26) .
a Remove:
- the steering box bolts (1) ,
- the steering box (2) .
REFITTING
132716
I - REFITTING PREPARATION OPERATION
a parts always to be replaced: Steering rack bolt
(13,04,03,05).
WARNING
-A 10 mm thick shim must be placed between
the radiator cross member and the sub-frame to
torque tighten the radiator cross member mountings
to the recommended torque.
- The wheels must be set straight ahead; centre
the steering wheel.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the steering box.
a Torque tighten the steering box bolts (105 N.m).
III - FINAL OPERATION
a Refit the front axle subframe (see 31A, Front axle
components, Front axle sub-frame: Removal -
Refitting, page 31A-26) .
36A-1