268954910-Renault-Scenic.pdf

TYRE PRESSURE MONITOR
Pressure sensor: Removal - Refitting
35B
II - HINGED TYRE PRESSURE MONITOR VALVE
III - ALL TYPES
115168 102242
a The following parts must be replaced:
- the seal with the metal ring (8) ,
- the mechanism (9) ,
- the retaining nut (10) ,
- the cap (11) .
a If necessary, replace:
- the coloured marker (12) .
a Make sure that the sensor is correctly positioned on
the wheel rim:
- figure 1 = fitted incorrectly,
- figure 2 = fitted correctly.
a Position the sensor in the valve opening, checking
that the seal is attached all around the edge of the
opening.
Note:
After using a tyre repair aerosol, remove the product
residue from the valve with a dry cloth or air
gun before refitting it on the wheel rim.
a Manually tighten the retaining nut, holding the pressure
sensor in contact with the rim.
a For hinged tyre pressure monitor valves, gently
press the cap towards the centre of the wheel, keeping
the sensor support on the rim to modify the valve/sensor
angle to the rim profile.
Tighten the nut manually.
a Tighten to the following torques:
- the tyre pressure monitor rigid sensor retaining
nut (7.5 Nm),
- the tyre pressure monitor hinged sensor retaining
nut (8.5 Nm).
a Refit the tyres (see 35A, Wheels and tyres, Tyres:
Removal - Refitting, page 35A-8) .
a Balance the wheels (see 35A, Wheels and tyres,
Wheel: Balancing, page 35A-4) .
35B-3