PC LOADER SOFTWARE INSTRUCTION MANUAL
PC LOADER SOFTWARE INSTRUCTION MANUAL PC LOADER SOFTWARE INSTRUCTION MANUAL
9.1. RECEIVED SIGNAL Select Tab Page 2 on the MAINTE screen and the following screen appears. Received signal Trigger level Fig. 9-2 RECEIVED SIGNAL screen • Select one from forward direction received wave, reverse direction received wave, forward direction filter, reverse direction filter and calculation waveform. • Click the [START] button to read in the specified cycle and click the [Stop] button to cancel the operation. Display is updated with each read. • Save the received waveform in the specified file by [SAVE As CSV] button. Trigger level is also displayed. • Display the RAS information in the STATUS DISPLAY. Point 1. Startup is completed within 3 to 6 waves. 2. No peak (amplitude) fluctuation should be observed. Otherwise air is mixed in. -28-
9.2. Adjustment of graph scale For adjusting scale, right-click on “Measurement”, “Waves” or “Velocity” screen. Example) For adjusting the scale of X axis, select X axis, input “Max.” and “Min.” on the scale tab. Click [OK] button. -29-
- Page 1 and 2: Instruction Manual PORTAFLOW C PC L
- Page 3 and 4: 1. OUTLINE 1.1. COPYRIGHT OF THIS S
- Page 5 and 6: (3) There is a query about the Lice
- Page 7 and 8: 2.2. Installing Microsoft .NET Fram
- Page 9 and 10: (5) After installation, the Complet
- Page 11 and 12: 2.4. Device Recognition (1) After t
- Page 13 and 14: Fig. 2-18 Installation confirmation
- Page 15 and 16: (3) There is a query about selectio
- Page 17 and 18: 3. Communication Specification See
- Page 19 and 20: 4.1. Version On the Menu screen, cl
- Page 21 and 22: 6. Measurement Click the “MEASURE
- Page 23 and 24: 7. Logger data Click the ”Logger
- Page 25 and 26: 8.1. Site Memory Select Tab Page 1
- Page 27 and 28: Item SENSOR MOUNT Table 8-3 Sensor
- Page 29: 9. Maintenance Click the “MAINTEN
- Page 33 and 34: 10.1. Flow velocity profile Select
- Page 35 and 36: 11. QUIT Click the Quit on the main
- Page 37 and 38: (2) Select the [Ports (COM & LPT)]
- Page 39 and 40: (3) The [Hardware Update Wizard] is
- Page 41 and 42: (8) Now, installation starts. If th
9.2. Adjustment of graph scale<br />
For adjusting scale, right-click on “Measurement”, “Waves” or “Velocity” screen.<br />
Example) For adjusting the scale of X axis, select X axis, input “Max.” and “Min.” on the scale tab. Click [OK] button.<br />
-29-