CONSTRUCTION OF GENERATOR CAPABILITY A CURVES
construction of generator ca atcs ca atcs capability curves construction of generator ca atcs ca atcs capability curves
Introduction Figure 1: Comparison chart of actual capability (P-Q) curves with the manufacturers' generator capability curves
BASIC PRINCIPLES FOR THE DESIGN OF CAPABILITY CURVE • Capability ity curve of generator e with unsaturated sauaed magnetic cc circuit cu • Generator is sized to reach the nominal temperature at the rated values of (p n ) and (q n ) powers (the point R) i.e.: • for induct currents, i a = i an = Const., φ ≤ φ n , and • curve i f = Const. . and φ > φ n , i.e., q ≥ q R , with a reduced active power p ≤ p R Figure 2: Vector diagram of generator electromotive forces and the excitation currents (with corresponding scaling ratio)
- Page 1 and 2: CONSTRUCTION OF GENERATOR CAPABILIT
- Page 3: Introduction • Capability curves,
- Page 7 and 8: BASIC PRINCIPLES FOR THE DESIGN OF
- Page 9 and 10: DETERMINATION OF GENERATORS POTIER
- Page 11 and 12: CONSTRUCTION OF GENERATOR CAPABILIT
- Page 13 and 14: Conclusion • It has been establis
- Page 15 and 16: Abstract The author came to the fol
- Page 17 and 18: THE POTIER REACTANCE DEPENDENCE ON
- Page 19 and 20: DETERMINATION OF POTIER REACTANCE (
- Page 21 and 22: Potier reactance dependence on the
- Page 23 and 24: Potier reactance dependence on the
- Page 25: Thank you for your attention
Introduction<br />
Figure 1: Comparison chart of actual capability (P-Q) curves with the manufacturers' generator capability curves