Instructions Manual
mirror - HeliFleet.com
mirror - HeliFleet.com
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
BAG-C<br />
Belt from box<br />
Hex Screw<br />
M2x6<br />
MSH 50098<br />
Tips/<strong>Instructions</strong><br />
Make sure hex screw M3x8 is fully tightened<br />
on bottom of main shaft than pulling main<br />
shaft gently lock collar in position.<br />
Main shaft should not have any vertical play.<br />
Hole nearer to side goes on top.<br />
Hex Screw<br />
M3x20<br />
MSH 50112<br />
Very Important !!<br />
After this step main shaft must not have<br />
any axial play !<br />
Nylon Nut<br />
M3<br />
MSH 50125<br />
MSH 50004<br />
Hex Screw<br />
M3x8<br />
MSH 50110<br />
MSH 50023<br />
Washer<br />
3.1x10x1<br />
MSH 50121<br />
Hex Screw<br />
M2x6<br />
MSH 50098<br />
Very Important !!<br />
Before sliding main shaft in position,<br />
insert belt from behind.<br />
Hex Screw<br />
M3x20<br />
MSH 50112<br />
Nylon Nut<br />
M3 4.3x5.5<br />
MSH 50125<br />
Washer<br />
3.1x10x1<br />
MSH 50121<br />
Hex Screw<br />
M3x8<br />
MSH 50110<br />
7
![Spartan Quark Gyro Installation Guide [Doc. v1.0] - Spartan RC](https://img.yumpu.com/53147979/1/190x196/spartan-quark-gyro-installation-guide-doc-v10-spartan-rc.jpg?quality=85)
Change language