Instructions Manual

More documents

Recommendations

Info

BAG-B Grub Screw M2.5x12 MSH 50115 Tips/<strong>Instructions</strong> Use thread lock on grub screw M2.5x12 on the side that goes in the servo frame. Grub screw can be screwed in by hand and tightened with MSH 50063 (Canopy post) using the two flat surfaces. Hex Screw M2.5x8 MSH 50103 MSH 50080 Grub Screw M2.5x12 MSH 50115 MSH 50063 Hex Screw M2.5x8 MSH 50103 6
BAG-C Belt from box Hex Screw M2x6 MSH 50098 Tips/<strong>Instructions</strong> Make sure hex screw M3x8 is fully tightened on bottom of main shaft than pulling main shaft gently lock collar in position. Main shaft should not have any vertical play. Hole nearer to side goes on top. Hex Screw M3x20 MSH 50112 Very Important !! After this step main shaft must not have any axial play ! Nylon Nut M3 MSH 50125 MSH 50004 Hex Screw M3x8 MSH 50110 MSH 50023 Washer 3.1x10x1 MSH 50121 Hex Screw M2x6 MSH 50098 Very Important !! Before sliding main shaft in position, insert belt from behind. Hex Screw M3x20 MSH 50112 Nylon Nut M3 4.3x5.5 MSH 50125 Washer 3.1x10x1 MSH 50121 Hex Screw M3x8 MSH 50110 7
Page 1 and 2: RC Helicopter Instructions Manual M
Page 3 and 4: BAG-A Tips/Instructions Hex screw M
Page 5 and 6: BAG-B Attention Hex Screw M2.5x6 MS
Page 7: Tips/Instructions Slide skid in bot
Page 11 and 12: 25.6 mm 28 mm Tips/Instructions BAG
Page 14 and 15: BAG-D MSH 50027 Tips/Instructions A
Page 16 and 17: BAG-D MSH 50088 Hex Screw M2x6 MSH
Page 18 and 19: Tips/Instructions Hex Screw M3x8 MS
Page 20 and 21: BAG-E BB 3x8x3 MSH 50033 Pin 3x14 M
Page 22 and 23: BAG-F Tips/Instructions Do not over
Page 24 and 25: BAG-F Tail Pitch Lever Screw M2.5x5
Page 26 and 27: BAG-F Hex Screw M3x12 MSH 50111 Hex
Page 28 and 29: 35 mm Rod E 35mm MSH 50045 BAG-G Ti
Page 30 and 31: Grub Screw M3x3 MSH 50117 Tips/Inst
Page 32 and 33: Tips/Instructions Use O ring MSH 50
Page 34 and 35: Spare Code Spare Description Part C

Instructions Manual

Create successful ePaper yourself

Delete template?

Save as template?