Instructions Manual

More documents

Recommendations

Info

BAG-F Tips/<strong>Instructions</strong> Do not over tight guide pulley screw, check that it turns freely after tightening the screw. Hex Screw M2.5x20 MSH 50107 Hex Screw M2.5x16 MSH 50106 Pin 1.5x8 MSH 50057 Washer 5x7.5x0.1 MSH 50135 Nylon Nut M2.5 MSH 50124 Washer 5x7.5x0.1 MSH 50135 Nylon Nut M2.5 MSH 50124 MSH 50073 Guide Pulley Bushing 2.5x3x7.8 MSH 50019 BB 3x8x3 MSH 50033 Hex Screw M2.5x20 MSH 50107 MSH 50079 Pin 1.5x8 MSH 50057 MSH 50073 BB 5x10x4 MSH 50034 MSH 50003 MSH 50078 Hex Screw M2.5x16 MSH 50106 MSH 50075 Glue together two halves with CA 20
! CAUTION MSH 50061 Tail pitch plate MSH 50099, must screw in to slide shaft MSH 50061 perfectly squared. MSH 50095 MSH 50093 MSH 50094 BB 7x11x3 MSH 50036 BAG-F Pin 1.5x8 MSH 50057 Pin 1.5x8 MSH 50057 21
Page 1 and 2: RC Helicopter Instructions Manual M
Page 3 and 4: BAG-A Tips/Instructions Hex screw M
Page 5 and 6: BAG-B Attention Hex Screw M2.5x6 MS
Page 7 and 8: Tips/Instructions Slide skid in bot
Page 9 and 10: BAG-C Belt from box Hex Screw M2x6
Page 11 and 12: 25.6 mm 28 mm Tips/Instructions BAG
Page 14 and 15: BAG-D MSH 50027 Tips/Instructions A
Page 16 and 17: BAG-D MSH 50088 Hex Screw M2x6 MSH
Page 18 and 19: Tips/Instructions Hex Screw M3x8 MS
Page 20 and 21: BAG-E BB 3x8x3 MSH 50033 Pin 3x14 M
Page 24 and 25: BAG-F Tail Pitch Lever Screw M2.5x5
Page 26 and 27: BAG-F Hex Screw M3x12 MSH 50111 Hex
Page 28 and 29: 35 mm Rod E 35mm MSH 50045 BAG-G Ti
Page 30 and 31: Grub Screw M3x3 MSH 50117 Tips/Inst
Page 32 and 33: Tips/Instructions Use O ring MSH 50
Page 34 and 35: Spare Code Spare Description Part C

Instructions Manual

Create successful ePaper yourself

Delete template?

Save as template?