Chapter 3 Accessing the GV-DSP LPR

More documents

Recommendations

Info

1.4.2 Rear View1 2 34Figure 1-2No. Name Function1 USB PortConnects to a UMTS modem.For details on UMTS, see [UMTS Setting] in 4.3.1 Lan.2 Ethernet Port Connects to a 10/100 Ethernet network.3 I/O Terminal BlockConnects digital inputs, relay outputs, RS-232 device andWiegand device.For details, see Chapter 6 The I/O Terminal Block.Note: Wiegand and RS-232 interface are NOT functional now.4 DC In 12V Connects the supplied power adaptor.4
2Getting StartedChapter 2 Getting StartedThis section provides basic information to get the GV-DSP LPR working on the network.2.1 Installing on a NetworkThese instructions describe the basic connections to install the GV-DSP LPR on thenetwork.12 3Figure 2-11. Connect the video output of your camera to the BNC video input.2. Connect the hub or switch on the LAN to the unit’s 10/100 Mbps Ethernet port.3. Connect the power supply to the power input.4. Wait until both Power and Ready LEDs are on and then you can set the IP address forthe unit.2.2 Assigning an IP AddressDesigned for use on an Ethernet network, the GV-DSP LPR must be assigned an IPaddress to make it accessible.Note: The GV-DSP LPR has a default address of 192.168.0.230. The computer used toset the IP address must be under the same IP and subnet sequence assigned to the unit.5
Page 1 and 2: GV-DSP LPRUser's Manual V1.0Before
Page 3 and 4: ContentsChapter 1 Introduction ....
Page 5 and 6: 1IntroductionChapter 1 Introduction
Page 10 and 11: 1. Open your web browser, and type
Page 12 and 13: Chapter 3 Accessing the GV-DSP LPRT
Page 14 and 15: 3.2.1 The Live View Window189234567
Page 16 and 17: 3.2.4 Video RecordingYou can record
Page 18 and 19: Chapter 4 Administrator ModeThe Adm
Page 20 and 21: [Video Signal Type] The GV-DSP LPR
Page 22 and 23: 4.1.3 LPR CenterWhen the alarm even
Page 24 and 25: 4.2.2 Output SettingThe GV-DSP LPR
Page 26 and 27: [UMTS Setting] UMTS stands for Univ
Page 28 and 29: To enable the DDNS function:1. Enab
Page 30 and 31: 4.4 ManagementThe Management sectio
Page 32 and 33: [Storage Settings]• Enable saving
Page 34 and 35: 4.4.5 ToolsThis section allows you
Page 36 and 37: 5.1.2 Upgrading Firmware by Using t
Page 38 and 39: 3. Click the Export Settings button
Page 40 and 41: Relay OutputThe relay outputs on th
Page 42: Country SupportAustralia, Austria,

Chapter 3 Accessing the GV-DSP LPR

Create successful ePaper yourself

Delete template?

Save as template?