Assembly Instructions for CN103 Series Connector Kits

Assembly Instructions for CN103 SeriesConnector Kits1. Strip outer jacket of wire .300”.2. Cut away the wire mesh shield and shield drain wire. (for twisted shieldedpair cable only)3. Strip the insulation from the conductor wires back .200”.4. Slide the silicone boot (if applicable), strain relief, and knurled ring (ifapplicable) onto the cable.5. Solder the accelerometer (+) wire (typically the white or red wire) to thesolder tab for pin ‘A’.6. Solder the accelerometer (-) wire (typically the black wire) to the solder tabfor pin ‘B’.7. Follow instructions on epoxy package.For Silicone boot connectors:1. Fill the strain relief body with epoxy up to the beginning of the threads.2. Thread the strain relief onto the threaded connector plug.3. Hang the connector below the cable (strain relief up, as shown) and allow todry. This is done to prevent the epoxy from running between the cable andthe strain relief.4. Once epoxy is dry (approximately 3 hours) push the silicone boot over theconnector assembly until it “snaps” into place.

For Mil-Style connectors:1. Slide the knurled ring over the threaded section of the connector plug.2. Thread the strain relief onto the connector plug.3. Fill the strain relief body with epoxy up to the top of the strain relief.4. Allow the epoxy to dry for approximately 3 hours.