Click Pack

More documents

Recommendations

Info

temperature, below 40°C, please look in the next appropriatecolumn. In case the temperature rises even more, please be awarethat at 50°C the load can only be 75% and at 60°C only 50% of theload at 40°C.Attention! The loads mentioned in the table can only serve as indications.On the basis of the table the number of containers that may bestacked can be calculated. It is the stacking load mentioned dividedby the product of the keg weight and the relevant safety factor. Thisnumber, with figures behind the comma smaller than eight, roundedoff + 1 = total number of containers.At the transit of one transport form to another, from storage totransport or from transport to storage, the bottom containers mustbe placed highest in the new stack.The containers must by stowed professionally and fixed in a waythat makes shifting impossible.For the use of pallets check instruction 6 Palletisation.For stacking and storing in a warehouse check instruction 4 Staticload.We advise users to test each new packaging method upfront.Click Pack manual 1404
06 Palletisation1. PalletA pallet must have an almost closed surface fitted with planks nomore than 5 cm apart. In case a pallet is placed on top of a ClickPack pallet, the surface needs to be flat and solid to avoid pressurepoints on the top layer.2. FormationCurTec advises to place the filled containers on a pallet as follows:Europallet 80 x 120 cm440612 pcs per layer4415 - 44208 pcs per layer4500 series6 pcs per layer100 x 120 cm/ 40 x 48”440618 pcs per layer4415 - 442010 pcs per layer4500 series9 pcs per layerClick Pack manual 1404
Page 1 and 2: ManualClick PackApril 2014
Page 3 and 4: 1 CloseA rubber mat (red) simplifie
Page 5 and 6: 9. The container is now sealed.Cont
Page 7 and 8: 03 Use1. Filling temperatureThe max
Page 9 and 10: 04 Static loadWhen stacking the Cli
Page 11: 05 Dynamic loadBefore stacking the
Page 15: CurTec InternationalSpoorlaan Noord

Click Pack

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?