Veritas Storage Foundation and High Availability Solutions Release Notes

More documents

Recommendations

Info

182Upgrading to 6.0.3Upgrading to 6.0.3Upgrading Veritas products using Live Upgrade from 6.0.1 to6.0.3 with OS upgradeThis section describes how to upgrade SF, SFHA, SFCFSHA, SFSYBASECE, or SFfor Oracle RAC from 6.0.1 to 6.0.3 using Live Upgrade where OS upgrade isinvolved.To upgrade your Veritas product using Live Upgrade1 Ensure that 6.0.1 is installed and configured on PBE.See your Veritas product 6.0.1 Installation Guide for more information.2 Run the vxlustart -V command to ensure there are no problems beforebeginning the Live Upgrade process.If the vxlustart -V command reports success, proceed with running thevxlustart command.If the vxlustart -V command reports errors, correct the problem, and runthe vxlustart -V command again.Note: This vxlustart -V command does not catch failures that are reportedby Solaris Live Upgrade commands.3 Run the vxlustart command to start the Live Upgrade for your Veritasproduct:# ./vxlustart -v -u target_os_version -s osimage_path -d disk_name4 If you are upgrading from Solaris 9 Update x to Solaris 10 Update y, uninstallVeritas products on ABE, else go to Step 6.# ./installprod -rootpath /altroot_path5 Install Veritas products again on ABE.# ./installprod -rootpath /altroot_path6 Run the installmr command to upgrade your Veritas product:# ./installmr -rootpath /altroot_path
Upgrading to 6.0.3Upgrading to 6.0.31837 In case of SFRAC, refer to the “Completing the Live upgrade” section in SFRAC6.0.1 Installation and Configuration guide. For other products, go to the nextstep.8 Run the vxlufinish command to complete the Live Upgrade:■If the primary root disk is not encapsulated, run the following command:# ./vxlufinish -u target_os_version■If the primary root disk is encapsulated by VxVM, run the followingcommand:# ./vxlufinish -u target_os_version -g diskgroup9 Restart all the nodes in the cluster. The boot environment on the alternatedisk is activated when you restart the nodes.# shutdown -g0 -y -i610 Verify that the alternate boot environment is active.# lustatus11 In a cluster environment, make sure that all the GAB ports are up. Note thatdifferent ports appear for different products.# gabconfig -a12 In case of SFRAC, refer to the “Performing post-upgrade Tasks” section torelink Oracle RAC libraries with SF Oracle RAC from 6.0.1 Installation andConfiguration guide.Performing a rolling upgrade using the installmr scriptYou can use rolling upgrades to upgrade one product from a release to the nextwith minimal application downtime.■■■About rolling upgradesPrerequisites for a rolling upgradesPerforming a rolling upgrade using the installer
Page 1 and 2:
Veritas Storage Foundationand High
Page 3 and 4:
Symantec Corporation350 Ellis Stree
Page 5 and 6:
■■■■■■■Hardware infor
Page 7 and 8:
ContentsTechnical Support .........
Page 9 and 10:
Contents9Chapter 4 Upgrading to 6.0
Page 11 and 12:
Chapter1About Veritas StorageFounda
Page 13 and 14:
About Veritas Storage Foundation an
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132: About Veritas Storage Foundation an
Page 149 and 150: Chapter2Installing the products for
Page 151 and 152: Installing the products for the fir
Page 153 and 154: Installing the products for the fir
Page 155 and 156: Chapter3Installing the productsusin
Page 157 and 158: Installing the products using JumpS
Page 163 and 164: Chapter4Upgrading to 6.0.3This chap
Page 165 and 166: Upgrading to 6.0.3Upgrading to 6.0.
Page 181: Upgrading to 6.0.3Upgrading to 6.0.
Page 193 and 194: Upgrading to 6.0.3Verifying softwar
Page 195 and 196: Chapter5Uninstalling version 6.0.3T
Page 197 and 198: Uninstalling version 6.0.3Rolling b
Page 221 and 222: AppendixAConfiguring VCS to managea
Page 223 and 224: Configuring VCS to manage a Logical
Page 233 and 234:
Configuring VCS to manage a Logical
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
show all

Veritas Storage Foundation and High Availability Solutions Release Notes

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?