Veritas Cluster Server Release Notes

Veritas Cluster Server Release Notes
Known issues
37
Manual upgrade of VRTSvlic RPM loses keyless product levels
[2737124]
If you upgrade the VRTSvlic RPM manually, the product levels that were set using
vxkeyless may be lost. The output of the vxkeyless display command will not
display correctly. To prevent this, perform the following steps while manually
upgrading the VRTSvlic RPM.
1. Note down the list of products configured on the node for keyless licensing.
# vxkeyless display
2. Set the product level to NONE.
# vxkeyless set NONE
3. Upgrade the VRTSvlic RPM
# rpm -Uvh --nopreun VRTSvlic-3.02.61.003-0.x86_64.rpm
4. Restore the list of products that you noted in step 1.
# vxkeyless set product[|,product]
While upgrading the VCS stack from a version prior to VCS 5.1,
reconfiguration of MultiNICA IPv4RouteOptions attribute is
required (2003864)
The 5.1SP1 MultiNICA agent now uses ip command by default. Due to behavioral
differences in ip and ifconfig commands in regards to route configuration,
MultiNICA flushes routes and sets them back for the new active device. If the
MultiNICA resource configuration is not intended to make use of ifconfig command
(see table below), you must configure IPv4RouteOptions attribute in MultiNICA
resource definition.
Note: RouteOptions values are used by the route command where as the
IPv4RouteOptions value is used by the ip route command. The values to be
configured for these two attribute are very specific to their respective commands.