Veritas Cluster Server 安 装 指 南
Veritas⢠Cluster Server å®è£ æå: Linux - Symantec Veritas⢠Cluster Server å®è£ æå: Linux - Symantec
98准 备 配 置 VCS 集 群 以 确 保 数 据 完 整 性设 置 CP 服 务 器11 输 入 数 据 库 的 绝 对 路 径 。CP Server uses an internal database to store the client information.As the CP Server is being configured on SFHA cluster, the database should resideon shared storage with vxfs file system. Please refer to documentation forinformation on setting up of shared storage for CP server database.Enter absolute path of the database: [b] /cpsdb12 验 证 并 确 认 CP 服 务 器 配 置 信 息 。CP Server configuration verification:CP Server Name: cps1CP Server Virtual IP(s): 10.200.58.231, 10.200.58.232CP Server Port(s): 65535, 14250CP Server Security: 1CP Server Database Dir: /cpsdbIs this information correct? [y,n,q,?] (y)13 该 安 装 程 序 将 继 续 进 行 配 置 过 程 , 并 创 建 vxcps.conf 配 置 文 件 。Successfully generated the /etc/vxcps.conf configuration fileCopying configuration file /etc/vxcps.conf to sys0....DoneCreating mount point /cps_mount_data on sys0. ... DoneCopying configuration file /etc/vxcps.conf to sys0. ... DonePress Enter to continue.14 配 置 此 集 群 的 CP 服 务 器 服 务 组 (CPSSG)。Enter the number of NIC resources that you want to configure. You must use a public NIC.Enter how many NIC resources you want to configure (1 to 2): 2Answer the following questions for each NIC resource that you want to configure.15 为 CP 服 务 器 进 程 的 虚 拟 IP 地 址 输 入 有 效 的 网 络 接 口 。Enter a valid network interface on linux92216 for NIC resource - 1: eth0Enter a valid network interface on linux92216 for NIC resource - 2: eth1
准 备 配 置 VCS 集 群 以 确 保 数 据 完 整 性设 置 CP 服 务 器9916 输 入 要 与 这 些 虚 拟 IP 地 址 相 关 联 的 NIC 资 源 。Enter the NIC resource you want to associate with the virtual IP 10.200.58.231 (1 to 2): 1Enter the NIC resource you want to associate with the virtual IP 10.200.58.232 (1 to 2): 217 输 入 每 个 NIC 资 源 的 网 络 主 机 信 息 。Symantec recommends configuring NetworkHosts attribute to ensure NIC resourceto be always onlineDo you want to add NetworkHosts attribute for the NIC device eth0on system linux92216? [y,n,q] yEnter a valid IP address to configure NetworkHosts for NIC eth0on system linux92216: 10.200.56.22Do you want to add another Network Host? [y,n,q] nDo you want to apply the same NetworkHosts for all systems? [y,n,q] (y)18 输 入 虚 拟 IP 地 址 的 网 络 掩 码 。 如 果 输 入 的 是 IPv6 地 址 , 请 在 提 示 符 处 输 入 前缀 详 细 信 息 。Enter the netmask for virtual IP 10.200.58.231: (255.255.252.0)Enter the netmask for virtual IP 10.200.58.232: (255.255.252.0)19 配 置 CP 服 务 器 数 据 库 的 磁 盘 组 。 可 以 选 择 现 有 磁 盘 组 或 创 建 新 磁 盘 组 。Symantec recommends to use the disk group that has at leasttwo disks on which mirrored volume can be created.Select one of the options below for CP Server database disk group:1) Create a new disk group2) Using an existing disk groupEnter the choice for a disk group: [1-2,q] 2
- Page 47 and 48: 计 划 安 装 VCS典 型 的 VCS
- Page 49 and 50: 4授 权 许 可 VCS本 章 节 包
- Page 51 and 52: 授 权 许 可 VCS安 装 Veritas
- Page 53: 部 分2安 装 前 任 务■5.
- Page 56 and 57: 56准 备 安 装 VCS执 行 安
- Page 58 and 59: 58准 备 安 装 VCS执 行 安
- Page 60 and 61: 60准 备 安 装 VCS执 行 安
- Page 62 and 63: 62准 备 安 装 VCS执 行 安
- Page 64 and 65: 64准 备 安 装 VCS执 行 安
- Page 66 and 67: 66准 备 安 装 VCS准 备 好 VC
- Page 68 and 69: 68准 备 安 装 VCS准 备 好 VC
- Page 70 and 71: 70准 备 安 装 VCS准 备 好 VC
- Page 72 and 73: 72准 备 安 装 VCS准 备 好 VC
- Page 75 and 76: 6安 装 VCS本 章 节 包 括 下
- Page 77 and 78: 安 装 VCS使 用 安 装 程 序
- Page 79 and 80: 安 装 VCS使 用 安 装 程 序
- Page 81 and 82: 7准 备 配 置 VCS 集 群 以
- Page 83 and 84: 准 备 配 置 VCS 集 群 以 确
- Page 85 and 86: 准 备 配 置 VCS 集 群 以 确
- Page 87 and 88: 准 备 配 置 VCS 集 群 以 确
- Page 89 and 90: 准 备 配 置 VCS 集 群 以 确
- Page 91 and 92: 准 备 配 置 VCS 集 群 以 确
- Page 93 and 94: 准 备 配 置 VCS 集 群 以 确
- Page 95 and 96: 准 备 配 置 VCS 集 群 以 确
- Page 97: 准 备 配 置 VCS 集 群 以 确
- Page 101 and 102: 准 备 配 置 VCS 集 群 以 确
- Page 103 and 104: 准 备 配 置 VCS 集 群 以 确
- Page 105 and 106: 准 备 配 置 VCS 集 群 以 确
- Page 107 and 108: 准 备 配 置 VCS 集 群 以 确
- Page 109 and 110: 8配 置 VCS本 章 节 包 括 下
- Page 111 and 112: 配 置 VCS指 定 用 于 配 置
- Page 113 and 114: 配 置 VCS配 置 专 用 心 跳
- Page 115 and 116: 配 置 VCS配 置 集 群 的 虚
- Page 117 and 118: 配 置 VCS将 Veritas Cluster Serv
- Page 119 and 120: 配 置 VCS逐 节 点 配 置 安
- Page 121 and 122: 配 置 VCS逐 节 点 配 置 安
- Page 123 and 124: 配 置 VCS配 置 SMTP 电 子 邮
- Page 125 and 126: 配 置 VCS配 置 SNMP 陷 阱 通
- Page 127 and 128: 配 置 VCS配 置 全 局 集 群1
- Page 129 and 130: 配 置 VCS验 证 和 更 新 系
- Page 131 and 132: 配 置 VCS验 证 和 更 新 系
- Page 133 and 134: 9配 置 VCS 集 群 以 确 保
- Page 135 and 136: 配 置 VCS 集 群 以 确 保 数
- Page 137 and 138: 配 置 VCS 集 群 以 确 保 数
- Page 139 and 140: 配 置 VCS 集 群 以 确 保 数
- Page 141 and 142: 配 置 VCS 集 群 以 确 保 数
- Page 143 and 144: 配 置 VCS 集 群 以 确 保 数
- Page 145 and 146: 配 置 VCS 集 群 以 确 保 数
- Page 147 and 148: 配 置 VCS 集 群 以 确 保 数
准 备 配 置 VCS 集 群 以 确 保 数 据 完 整 性设 置 CP 服 务 器9916 输 入 要 与 这 些 虚 拟 IP 地 址 相 关 联 的 NIC 资 源 。Enter the NIC resource you want to associate with the virtual IP 10.200.58.231 (1 to 2): 1Enter the NIC resource you want to associate with the virtual IP 10.200.58.232 (1 to 2): 217 输 入 每 个 NIC 资 源 的 网 络 主 机 信 息 。Symantec recommends configuring NetworkHosts attribute to ensure NIC resourceto be always onlineDo you want to add NetworkHosts attribute for the NIC device eth0on system linux92216? [y,n,q] yEnter a valid IP address to configure NetworkHosts for NIC eth0on system linux92216: 10.200.56.22Do you want to add another Network Host? [y,n,q] nDo you want to apply the same NetworkHosts for all systems? [y,n,q] (y)18 输 入 虚 拟 IP 地 址 的 网 络 掩 码 。 如 果 输 入 的 是 IPv6 地 址 , 请 在 提 示 符 处 输 入 前缀 详 细 信 息 。Enter the netmask for virtual IP 10.200.58.231: (255.255.252.0)Enter the netmask for virtual IP 10.200.58.232: (255.255.252.0)19 配 置 CP 服 务 器 数 据 库 的 磁 盘 组 。 可 以 选 择 现 有 磁 盘 组 或 创 建 新 磁 盘 组 。Symantec recommends to use the disk group that has at leasttwo disks on which mirrored volume can be created.Select one of the options below for CP <strong>Server</strong> database disk group:1) Create a new disk group2) Using an existing disk groupEnter the choice for a disk group: [1-2,q] 2