Veritas Cluster Server Bundled Agents Reference Guide

Troubleshooting bundled agents
Troubleshooting NetApp agents
217
Recommended Action: Make sure that the VCS Helper Service account has domain
admin privileges and is part of the administrator's group on the local host and
the filer.
Make sure the private network is functioning properly. Verify you can ping the
IP used for the private storage network. This is the IP defined the StorageIP
attribute of the NetAppFiler resource.
Failed to initialize ONTAPI on system
The agent could not find the file NTAPADMIN.DLL on the system.
Recommended Action: Verify the file exists in the %VCS_HOME%\bin directory.
Invalid attributes exist in the configuration
Some agent attributes have not been defined or have been defined incorrectly.
Recommended Action: Verify the configuration definition for the agent.
ONTAP API called failed for object_name on filer_name.
The specified API failed on the specified object.
Recommended Action: See the NetApp ONTAP API documentation for information
about the associated error message
Volume %s on filer %s is not a SnapMirror replicated volume
Recommended Action: Verify replication is set up on the specified volume.
Multiple snapmirror destinations for a volume is not supported by this agent.
‘snapmirror status’ for volume %s on filer %s returned multiple status entries.
Administrative intervention required
Recommended Action: There should be only one destination per source volume.
InitializeVLibNetAppHost::Initialize()failed.(error_type:%s,error_code:0x%s)
The agent could not detect the iSCSI or the FC Initiator on the host.
Recommended Action: Make sure that you have installed and configured Microsoft
iSCSI Initiator or an FC Initiator on each node.
Failed to connect/disconnect virtual disk. (error_type: %s, error_code: 0x%s.
error_message: %s)
This could occur because one or more of the following parameters are defined
incorrectly in the VCS configuration:
■
■
■
Filer name
Volume name/LUN name
Share name