INSTRUCTIONS

TUNER OPERATIONTuner OperationBy pressing16and18(Channel 1 & 3) at the same time the amplifier willMute and the tuner function will be activated. (Note any signal connected tothe Auxiliary input will not be muted)The LED in17(Channel 2) will flash to indicate Tuner operation.3The AMP selector should then be used to select each string in turn to betuned.These are E,B,G,D,A,E and numbered 1-6 with 1 being the High “E” and 6being Low “E”Adjust the string tension to make just the centre LED light.(As the tune is approached, the centre LED and the LED from the directionof tune will speed up flashing to show you are getting close to the in tuneposition.When in tune the LEDs will stop flashing and only the Centre LED will becontinuously lit.Repeat this for each string and then go back through them again to makefinal adjustments if required.16 17 18 19To exit the tuner function press16&18at the same time again.Alternatively remove the input jack and replace.(You will be returned to the amp model and sound settings prior to tuning.)