Richter Bass

BLOCK DIAGRAMINPUTNORMALHIGHPADTUNER OUTGAIND.I. OUTONACTIVECOMPRESSORSECTIONEQ SECTIONVOLUMESENDFX LOOPRETURNThis loop is a series type so allyour signal will go through your FX unit.POWERAMPOUTPUTACTIVEX-OVERH.F HORNLIMITERSECTIONINTERNALLOUDSPEAKERAmplifier connection: In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off yourequipment. With all system parts connected, turn on source equipment, tape decks, cd players, mixers, effects processors etc. BEFOREturning on your Bass Amplifier. Many products have large transient surges at turn on and off which can cause damage to yourspeakers. By turning on your Bass Amplifier LAST and making sure its Volume control is set to minimum any transients from otherequipment will not reach your loudspeakers. Wait until all system parts have stabilised; usually a couple of seconds. Similarly whenturning off your system always turn down the Volume control on your Bass Amplifier and then turn off its power before turning offother equipment.Cables: Never use shielded or microphone cable for any speaker connections as this will not be substantial enough to handle theamplifier load and could cause damage to your amplifier system.Servicing: The user should not attempt to service these products. Refer all servicing to qualified service personnel.13