EFXac 100/125 - Jungheinrich

Maintenance intervalsStandard = t W1M3M6M12Lifting device 10.1 Apply grease to rollers and lateral running surfaces ofthe guide rollers in the lifting mast profiles and in theswivel/traverse unit.tAttention: Danger of falling down!fLoad-carryingattachmentsLubrication:10.2 Check lifting mast attachment t10.3 Check the lifting chains and chain guide for wear, adjustand greaset10.4 Perform sight check of rollers, sliding elements, andstopst10.5 Check lifting mast bedding t10.6 Check fork arms and fork arm carriage for wear anddamaget10.7 Grease all lubrication locations of the guide rollers of thelifting mastt11.1 Performance check t11.2 Check secure attachment at truck and supportingelements11.3 Check bearings, guides, and stops for wear anddamage; clean and grease, also grease the toothed tracks11.4 Check eccentric bolt and glide bar adjustment at swivel/traverse frame and re-adjust, if necessary.t11.5 Grease guide rollers and swivel bearing of the swivel/traverse fork.t12.1 Grease the industrial truck in accordance with thelubrication schedulet13.1 Check the electrical system for a grounding fault t13.2 Check travel speed and braking distance t13.3 Check lifting and lowering speed t13.4 Check cut-off functions t13.5 IG: Measure current in guide wire and adjust, ifnecessaryt13.6 Check travel behaviour on IG wire and maximumdeviation and re-adjust, if necessaryt13.7 Check tracking-in mode on the IG wire for aisle trackingttGeneralmeasurements:Demonstration:13.8 Check EMERGENCY STOP function of IG t14.1 Perform trial run under nominal load t14.2 Upon completion of servicing operations, demonstratethe vehicle to the person responsiblet1102.GBF 6