EFXac 100/125 - Jungheinrich

OFFmanualsemi-automaticautomaticNo desired height set (desired height must approachedmanually).The hydraulic control knob must be actuated until thedesired height is reached.The hydraulic control knob must be actuated untilshortly before reaching the desired height.The hydraulic control knob must be tapped into thedesired direction, the desired height is thenautomatically approached.If another shelf is selected during the positioning process, this value is stored in abuffer and shown for approx. one second in the display. When the stacking cycle isfinished the shelf is automatically retrieved from the buffer.Depending on the variant the following variations are possible for the stacking cycle:1. Stacking cycle not active.2. Stacking and retrieving is predefined by the load sensor. The individual functionssuch as traversing, lifting, and lowering are performed by the driver. Afterreaching the respective end position the next work step can be carried out. Thedriver can select all hydraulic speeds.3. The hydraulic control knob must be held in the desired direction during the entirestacking process. The driver can control the stacking setpoint while stacking is inprogress.AfCareful stacking is thus possible with and without load while retracting occurswith a fixed setpoint.All automatic cycles can be interrupted by stepping on the foot switch.In case of danger actuate the EMERGENCY OFF switch.1102.GBE 33