EFXac 100/125 - Jungheinrich

Setting down loadsfm– Carefully approach the storageposition with the truck.Before the load can be set down thedriver must verify that the storageposition is suited for the load(dimensions and carrying capacity).– Do not actuate the foot switch.– Lift the load-carrying unit until the loadcan be inserted into the storageposition without colliding.– Carefully push the load into thestorage position.– Carefully lower the load-carrying unituntil the fork arms are clear off theload.Avoid setting down the load heavily, inorder not to damage load and loadcarryingunit.– Carefully shift load-carrying unit out ofthe load.– Fully lower the load-carrying unit.4.5 Lifting height preselection (o):To pick up or set down loads at preselected storage locations, the truck must beadjusted to the warehouse facilities. The work required for this purpose may only becarried out by customer service.Storage location recognition (zones)The zones are entered via number keys or input keys F1 - F7.Picking up or setting down load in preselected storage locations with heightpreselection:– Drive truck into the corresponding aisle– Enter the shelf number.The shelf number is entered via the number keys.The shelf number can be entered as a single digit (1- 9) or two digits (01 - 64).The entry can be deleted with the “CE” key.If height “0” is entered for the selected shelf, the height preselection is not active.Depending on the parameter settings there are different operating methods to reachthe desired height:1102.GBE 32