EFXac 100/125 - Jungheinrich

Picking up a load with swivel/traverse fork from the frontAfffAA– Swivel the swivel/traverse fork 90°away from the transport position andtraverse to the centre axis of the truck.The swivel/traverse fork is nowpositioned in travel direction.– Lift the swivel/traverse forkrespectively lower to the proper heightwith respect to the load, so that thefork arms can be inserted under theload without damaging it.Lifting persons is prohibited.– Carefully move the truck into thedirection of the load until the loadmakes contact with the back of thefork.The fork arms must be inserted into theload with their full length.– Do not actuate the foot switch.– Lift the swivel/traverse fork slightly sothat the load is clear off the ground.– Step on the foot switch.– Drive the truck carefully in drivedirection only as far until the load isfree.This operating mode is only allowed atthe stack!Make sure that nobody steps under thelifted load.– Do not actuate the foot switch.– Lower the load.– Move the swivel/traverse fork intransport position.The swivel/traverse fork must beswivelled crossways to the traveldirection and must be positioned in leftrespectively right transport position.The picked up load can now betransported.Rotating loads > 500 kg at heights above2 m is not possible.1102.GBE 30