EFXac 100/125 - Jungheinrich

More documents

Recommendations

Info

– Push “Guidance” (26) button.– The drive wheel is automatically setstraight and the indicator lamp“Guidance ON” (25) is inverted.Manual steering is out of operation.– Continue to drive the truck at thedesired speed in the aisle.fffTrucks with inductive guidanceWhen starting or continuing to travel after switching off inductive guidance you mustobserve the position of the drive wheel, as manual steering is active again.If an inductively forced guided truck is switched off, the inductive guidance will nolonger be active when the truck is switched on again. Danger of accidents! When thetruck is not braked, a warning signal is issued and the speed is reduced. Presspushbutton (26) to activate inductive guidance again (indicator lamp “Inductiveguidance active”(25) lights up) and track-in the truck again.During the tracking-in procedure the truck’s rear section might break out of line undercertain circumstances if the front sensor (36) has already crossed the guide wirebefore the button “Inductive guidance ON” has been pushed.– Drive the truck (34) diagonally atreduced speed towards the guide wire(35).When tracking-in, the truck must not bein parallel to the guide wire and theapproaching angle should be between10° and 35°.36The tracking-in procedure should beperformed in load direction, since therequired time and distance are smallestin this direction.– When near the guide wires of theinductive guidance system, actuatepushbutton (26).The indicator lamp “Inductive guidanceactive” (25) illuminates.3534When the guide wire is reached, thetruck is automatically guided.The tracking-in procedure is automatically executed at reduced travel speed whenthe guide wire is reached. The display for “Tracking-in” (21) lights up. The auditivetracking signal is sounded.1102.GBE 25
The inductive forced steering takes oversteering of the truck and turns it to theguide wire.After the truck is exactly tracking theguide wire the tracking-in procedure iscompleted. The display (21) changes to“Wire-guided”. The tracking-in signal isno longer sounded. The truck is nowforce-guided.The maximum travel speed is enabled.fTo leave the guide wire the pushbutton(26) for inductive forced steering mustbe actuated.Switching over to manual steering may only be performed when the entire truck hasleft the aisle.If during inductive guidance of the truck the guiding antenna leaves the predefinedlevel area of the guide wire, an emergency stop is initiated immediately.1102.GBE 26
Page 4 and 5:
Table of contentsABCorrect use and
Page 6 and 7: FMaintenance of the fork lift truck
Page 8 and 9: AACorrect use and application of th
Page 10 and 11: BTruck description1 Application des
Page 12 and 13: Item Designation1 t Lifting mast2 t
Page 14 and 15: Driver position:The spacious, ergon
Page 16 and 17: m1rl 8l 1l 21102.GBb7Astb12b5b1b2b6
Page 18 and 19: 3.4 EN standardsContinuous sound le
Page 20 and 21: 4.1 Truck identification plate30423
Page 22: CTransportation and commissioning1
Page 26 and 27: D Battery - Servicing, recharging,r
Page 28 and 29: 3 Charging the batteryffPark and lo
Page 30 and 31: 5 Check battery condition, acid lev
Page 32 and 33: EOperation1 Safety regulations gove
Page 34 and 35: 2.1 Foot-operated elements121314Ite
Page 36 and 37: Item Symbol Operating anddisplay el
Page 38 and 39: Symbol Operating or displayelementG
Page 40 and 41: Additional symbol displaysTurn cut-
Page 42 and 43: Personnel protection facility force
Page 44 and 45: Symbol allocation displayTTime of d
Page 46 and 47: 3.2 Mounting and descending from th
Page 48 and 49: fManaging extraordinary situationsI
Page 50 and 51: 3.6 Providing operational readiness
Page 52 and 53: Travelling in aisles: Before drivin
Page 54 and 55: SteeringOutside of aisles the truck
Page 58 and 59: 4.3 Lifting - lowering - traversing
Page 60 and 61: 4.4 Picking up, transporting, and p
Page 62 and 63: ffPicking up and setting down a loa
Page 64 and 65: OFFmanualsemi-automaticautomaticNo
Page 66 and 67: 5 TroubleshootingThis chapter allow
Page 68 and 69: 6.4 End of aisle safety device (o)V
Page 70 and 71: 6.7 Emergency lowering of the load-
Page 72 and 73: Disengaging the solenoid brake- Rem
Page 74 and 75: FMaintenance of the fork lift truck
Page 76 and 77: 3 Servicing and inspectionmThorough
Page 78 and 79: a) Check wheel nuts for tight seat
Page 80 and 81: A5 Lubrication scheduleFEEFGGFE0,18
Page 82 and 83: 6 Notes on maintenance6.1 Prepare t
Page 84 and 85: 6.7 Cleaning the aeration filterScr
Page 86 and 87: 6.10 Checking the brake fluidfBrake
Page 88 and 89: 6.13 Recommissioning the truckRecom
show all

EFXac 100/125 - Jungheinrich

Create successful ePaper yourself

Delete template?

Save as template?