EFXac 100/125 - Jungheinrich

– Push “Guidance” (26) button.– The drive wheel is automatically setstraight and the indicator lamp“Guidance ON” (25) is inverted.Manual steering is out of operation.– Continue to drive the truck at thedesired speed in the aisle.fffTrucks with inductive guidanceWhen starting or continuing to travel after switching off inductive guidance you mustobserve the position of the drive wheel, as manual steering is active again.If an inductively forced guided truck is switched off, the inductive guidance will nolonger be active when the truck is switched on again. Danger of accidents! When thetruck is not braked, a warning signal is issued and the speed is reduced. Presspushbutton (26) to activate inductive guidance again (indicator lamp “Inductiveguidance active”(25) lights up) and track-in the truck again.During the tracking-in procedure the truck’s rear section might break out of line undercertain circumstances if the front sensor (36) has already crossed the guide wirebefore the button “Inductive guidance ON” has been pushed.– Drive the truck (34) diagonally atreduced speed towards the guide wire(35).When tracking-in, the truck must not bein parallel to the guide wire and theapproaching angle should be between10° and 35°.36The tracking-in procedure should beperformed in load direction, since therequired time and distance are smallestin this direction.– When near the guide wires of theinductive guidance system, actuatepushbutton (26).The indicator lamp “Inductive guidanceactive” (25) illuminates.3534When the guide wire is reached, thetruck is automatically guided.The tracking-in procedure is automatically executed at reduced travel speed whenthe guide wire is reached. The display for “Tracking-in” (21) lights up. The auditivetracking signal is sounded.1102.GBE 25