EFXac 100/125 - Jungheinrich

mAATravelling in aislesUnauthorised personnel and through-traffic for personnel is not allowed in aisles(travel paths for trucks in racking systems without safety distance for oncomingpersons(as stipulated by VBG636§28, section 1). Such working areas must bemarked accordingly. Existing protection devices at trucks or the racking system forpreventing dangerous situations and protecting personnel must be checked on a dailybasis (as per DIN 15185-2). Such devices must not be rendered unusable, must notbe misused, maladjusted, or removed. Malfunctions on safety devices must bereported and repaired immediately.Before driving into an aisle the driver must check whether persons or other trucks arein this aisle. Only free aisles may be entered. If personnel is in the aisle, the operationmust be stopped immediately.Driving into aisles is only allowed with trucks that have been designed for thisoperation. If an aisle is equipped with an inductive guide wire system and theinductive guide wire system is defective or switched off, the truck may only be drivenout of the aisle at inching speed.Diagonal travelDiagonal travel is possible bysimultaneously actuating hydrauliccontrol lever (9) and stepping downaccelerator pedal (14) (simultaneoustravelling and lifting or lowering).914fATrucks with rail guidanceThe rail height must be at least 40 mm.Rail-guided trucks are equipped with sensors that activate the aisle detection whenentering the rack aisles.– Position the truck at reduced speed in front of the aisles, so that it is aligned withthe aisle and its markings.Observe the signs affixed to the travel paths.– Slowly drive truck into the aisle.Observe that the guide rollers of the truck fully thread into the guide rails of the aisle.1102.GBE 24