material safety data sheet dc 200 - ChemCenters

QUICK IDENTIFIER(as used in label and list)DC 200 FluidMATERIAL SAFETY DATA SHEET________________________________________________________________________________SECTION IPRODUCT IDENTIFICATION________________________________________________________________________________COMMON NAMEPRODUCT MODEL NUMBERDow Corning 200 FluidDC200PRODUCT FILE NUMBERPRODUCT USE920:405-DC200-9Fill FluidMANUFACTURER'S NAMEEMERGENCY PHONE NUMBERSDow Corning1-800-424-9300 (US), 1-703-527-3887 (International)ADDRESSENGINEERING CONTROL DATASouth Saginaw Road MSDS - A35812-1, Rev. J, EO 5244Drawing – A34046CITY, STATE, ZIPDATE PREPAREDMidland, Michigan 48686 4-8-02________________________________________________________________________________SECTION IIHAZARDOUS INGREDIENTS________________________________________________________________________________1.Chemical Name: Polydimethylsiloxane (Silicone)CAS No: 63148-62-9OSHA/PEL: NEACGIH/TVL: NE% : 100________________________________________________________________________________SECTION III PHYSICAL & CHEMICAL DATA________________________________________________________________________________BOILING POINT SPECIFIC GRAVITY (H 2O=1) VAPOR PRESSURE (mmHg)300° F 149° C 0.94

________________________________________________________________________________SECTION IVFIRE & EXPLOSION DATA________________________________________________________________________________FLASH POINT METHOD USED FLAMMABLE LIMITS (in Air % by Vol.) LEL UEL325° F/163° C Open cup ND NDAUTO-IGNITION TEMPERATURE EXTINGUISHER MEDIANot DeterminedWater spray, CO 2 , Dry Chemical, FoamSPECIAL FIRE FIGHTING PROCEDURESEvacuate area of all unnecessary personnel. Use NIOSH/MSHA approved self-contained breathing apparatus and otherprotective equipment.UNUSUAL FIRE AND EXPLOSION HAZARDSNone________________________________________________________________________________SECTION VREACTIVITY DATA________________________________________________________________________________STABILITYCONDITION TO AVOIDStableNoneINCOMPATIBILITY (Materials to Avoid)Oxidizing material can cause a reaction. Also, strong acids and bases may react with this product.HAZARDOUS DECOMPOSITION PRODUCTSSilicon dioxide, carbon dioxide, and traces of incompletely burned carbon products. Traces of formaldehyde may formduring fire or very high heat conditions.HAZARDOUS POLYMERIZATION CONDITIONS TO AVOIDWill not occurnone________________________________________________________________________________SECTION VIHEALTH HAZARDS________________________________________________________________________________ACUTEEYESMay cause mild irritation, redness, and tearing.SKIN CONTACTSingle prolonged exposure (hours) causes no known effect. Several repeated, prolonged exposures may cause slightirritation.INGESTIONAmounts transferred to the mouth by fingers, etc., during normal operations should not cause injury.INHALATIONNo irritation nose or throat expected. No injury is likely from relatively short exposures.CHRONIC EFFECTS OF EXPOSURENo known adverse chronic health effects, but unnecessary exposure to any chemical should be avoided. This product, aswith any chemical, may enhance allergic conditions on certain people. To the best of our knowledge there are no medicalconditions that might be aggravated by exposure to this product.________________________________________________________________________________QUICK IDENTIFIER - DC 200 Fluid Page 2 of 4

CHEMICAL LISTED AS CARCINOGEN OR POTENTIAL CARCINOGENNational Toxicology Program I.A.R.C. Monographs OSHANA NA NA________________________________________________________________________________SECTION VII EMERGENCY & FIRST AID PROCEDURE________________________________________________________________________________EYESImmediately flush eyes with plenty of water for at least 15 minutes while holding eyelids open.SKIN CONTACTRemove contaminated clothing and wash with soap and water. Wash contaminated clothes.INHALATIONNot a problem.INGESTIONNot a problem.________________________________________________________________________________SECTION VIII SPILL OR LEAK PROCEDURES________________________________________________________________________________RESPONSE TO SMALL SPILLSAbsorb with absorbent material. Dispose of properly.WASTE DISPOSALPlace in an appropriate disposal facility in compliance with Federal, State, and Local regulations.________________________________________________________________________________SECTION IXSPECIAL PROTECTION INFORMATION________________________________________________________________________________RESPIRATORY PROTECTIONNot typically required. If exposure exceeds permissible exposure limits, wear a self-contained breathing apparatus incompliance with NIOSH/MSHA specifications. Comply with 29 CFR 1910.134VENTILATIONGeneral (mechanical) room ventilation is generally satisfactory.PROTECTIVE GLOVESNot generally required.EYE PROTECTIONWear chemical goggles if there is likelihood of contact with eyes.ADDITIONAL PROTECTIVE CLOTHING OR EQUIPMENTEye wash fountains and safety showers should be available for emergency use.________________________________________________________________________________QUICK IDENTIFIER - DC 200 Fluid Page 3 of 4

________________________________________________________________________________SECTION XTRANSPORTATION________________________________________________________________________________Proper Shipping Name: NAHazard Class or Division: NAIdentification Number: UN2504Packing Group: NAPacking Authorization: D.O.T. 49 CFR 173.154 & 173.203IATA Packing Instructions: 611________________________________________________________________________________SECTION XISPECIAL PRECAUTIONS________________________________________________________________________________-THIS PRODUCT IS FOR INDUSTRIAL AND LABORATORY USE ONLY-Do not store in open, unlabeled or mislabeled containers.-Store in cool, dry place with adequate ventilation.-Keep away from flames and high temperatures.-For personal hygiene protection, we recommend that employees washthoroughly after handling product. Always wash up before eating, smoking,and using toilet facilities.-Keep out of reach of children.-HMIS rating HEALTH - 0 FLAMMABILITY - 1 REACTIVITY - 0________________________________________________________________________________DISCLAIMER OF LIABILITYThe information contained herein is, to the best of our knowledge and belief, accurate. However, since the conditions of handling and use are beyond our control, we makeno guarantee of the results, and assume no liability for damages incurred by use of this material. All chemicals may present unknown health hazards and should be usedwith caution. Although certain hazards are described herein, we cannot guarantee that these are the only hazards that exist. Final determination of suitability of the chemicalis the sole responsibility of the user. User of any chemical should satisfy themselves that the conditions and methods of use assure that the chemical is used safely. NOREPRESENTATIONS OR WARRANTIES, EITHER EXPRESS OR IMPLIED, OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR ANY OTHERNATURE ARE MADE HEREUNDER WITH RESPECT TO THE INFORMATION CONTAINED HEREIN OR THE CHEMICAL TO WHICH THE INFORMATION REFERS. It isthe responsibility of the user to comply with all applicable federal, state, local laws and regulations.________________________________________________________________________________QUICK IDENTIFIER - DC 200 Fluid Page 4 of 4