Grease separator

DescriptionKESSEL Version „D“ separators are designed according to EN 1825-1.These separators distinguish themselves through their ease of installationand nearly maintenance free characteristics.The advantage of the Version „D“ separator is that disposal can takeplace through permanently installed disposal lines while the twincovers of the separator remain closed. With this advantage, the disposaltruck can hook up to a connection on an exterior wall of the buildingand, using its own pump, suction out the entire contents of theseparator without any unpleasant odors escaping. According to DIN V4040-2, the complete contents of the separator should be emptied, theunit cleaned and refilled with clean cold water every fourteen days orat a minimum of every month.Installation hintsImportant is that a testing or sampling chamber is installed after the outletside of the separator.The separator is installed completely level on a flat firm surface in a frostfree area.The height of the room in which the separator is installed should alloweasy removal and access of the two lids.In the case that the outlet of the separator is located below the localdefined backwater level, a lifting station is to be installed according toDIN 1986-7. In situations where the interruption of separator service isnot allowable, a lifting station with double pumps is to be installed.NoticeThe KESSEL Version „D“ separator should be inspected and fullycleaned during every third disposal.In all circumstances where the accessibility of the disposal truck’ssuction hose to the separator is highly limited or impossible, KESSELrecommends the installation of a Version „D“ unit.With the installation of the refill equipment, the KESSEL Version „D“separator can be refilled after disposal without the need of openingany of the covers and releasing strong and aggressive odors.The KESSEL Version „D“ separator is not intended for use in meatprocessing plants.Page 17