KESSEL Grease separator âMâ NG 2, 4, 7 and 10 For installation in ...

More documents

Recommendations

Info

7.1 Sampling chamber DN 100 or DN 1507. Accessories / Replacement partsKESSEL offers various sampling chambers for installation in frost free rooms or for undergroundinstallation. Sampling chambers are odour tight and are opened and closed by a quick releaselocking clamp. This sampling chamber makes it possible to take samples of the grease freewastewater for testing (according to DIN 38409). Each chamber is equipped with a DN 100 andDN 150 inlet and outlet. The required sizes can be obtained by cutting off the respective section.Type Art. #Horizontal outlet 915 871Vertical outlet 915 8707.2 Lifting stationsKESSEL offers various lifting stations for installation after the separator so that the effluent can bepumped up to sewer levels.Output Power Outlet Art. #size1,1 kW 400 V direct (3- DN 100 28 659Phase)2,2 kW 400 V direct (3-Phase)DN 100 28 631• The KESSEL Aqualift ®F for grey or sewageeffluent for frost free areas consists of:• Submersible (IP 68) single or double pumps units with single vane impellers (40mmmaximum passage) and rotation direction indicator and 5 meter connection cable• DN 100 Outlet (pressure) with backflow preventer and rubber coupling• Control unit for fully automatic pump control, splash-proof (IP65), wall mounted, operatedon 400 V direct or 230 V alternating current at 50 Hz.• A polyethylene collection chamber• Pneumatic level control• Clean-out• DN 100 inlet ready• DN 70 ventilation port• DN 32 emergency hand pump port12
7.3 Replacement Parts7. Accessories / Replacement partsArticle Art. #For grease separators according to DIN 4040 Plastic cover Ø 630 mm Cover gasket Ø 630 mm Quick release clamp for cover Ø 630 mmFor grease separators according to EN 1825 Cover Ø 420 mm Cover gasket Ø 420 mm Quick release clamp for coverFor all KESSEL grease separators916 901917 201917 001916 904916 204916 402 Disposal pump with cutting blades 2,2 kW Disposal pump with cutting blades 4 kW916 401916 4028. Guarantee1. In the case that a KESSEL product is defective, KESSEL has the option of repairing or replacingthe product. If the product remains defective after the second attempt to repair or replace theproduct or it is economically unfeasible to repair or replace the product, the customer the has theright to cancel the order / contract or reduce payment accordingly. KESSEL must be notifiedimmediately in writing of defects in a product. In the case that the defect is not visible or difficult todetect, KESSEL must be notified immediately in writing of the defect as soon as it is discovered. Ifthe product is repaired or replaced, the newly repaired or replaced product shall receive a newwarranty identical to that which the original (defective) product was granted. The term defectiveproduct refers only to the product or part needing repair or replacement and not necessarily to theentire product or unit. KESSEL products are warranted for a period of 24 months. This warrantyperiod begins on the day the product is shipped from KESSEL to its customer. The warranty onlyapplies to newly manufactured products. Additional information can be found in section 377 and378 of the HGB.2. Wear and tear on a product will not be considered a defect. Problems with products resultingfrom improper installation, handling or maintenance will also not be considered a defect.01.01.200213
Page 1 and 2: INSTALLATION AND OPERATING INSTRUCT
Page 6 and 7: 2. Installation2.3 Electrical Insta
Page 9 and 10: 5. Disposal for grease separator ac
Page 11: 6. MaintenanceMaintenance of the se
Page 15 and 16: Important contacts / InfoSeparator
Page 17 and 18: Electrical SchematicElectrical sche
Page 19 and 20: Electrical SchematicFront view cont
Page 21: Everything for drainage Backwater v

KESSEL Grease separator âMâ NG 2, 4, 7 and 10 For installation in ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

KESSEL Grease separator âMâ NG 2, 4, 7 and 10 For installation in ...