KESSEL Grease separator âMâ NG 2, 4, 7 and 10 For installation in ...
KESSEL Grease separator âMâ NG 2, 4, 7 and 10 For installation in ...
KESSEL Grease separator âMâ NG 2, 4, 7 and 10 For installation in ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
6. Ma<strong>in</strong>tenanceMa<strong>in</strong>tenance of the <strong>separator</strong>The <strong>separator</strong> should be tested to make sure that it is completely watertight before it is placed <strong>in</strong>tooperation <strong>and</strong> also dur<strong>in</strong>g periodic <strong>in</strong>tervals thereafter. The macerat<strong>in</strong>g pump as well as the waternozzles are practically ma<strong>in</strong>tenance free.1. Surface care - the <strong>in</strong>terior walls of the <strong>separator</strong> should be cleaned <strong>and</strong> checked forproblems at regular <strong>in</strong>tervals.2. The controls (control unit <strong>and</strong> software) of the <strong>separator</strong> are ma<strong>in</strong>tenance free. Thecapacitive level switch should be checked dur<strong>in</strong>g the bi-annual <strong>in</strong>spection (see electrical<strong><strong>in</strong>stallation</strong>).3. The <strong>separator</strong> should be thoroughly checked two times per year. Dur<strong>in</strong>g these <strong>in</strong>spectionsthe <strong>separator</strong> should be completely emptied <strong>and</strong> thoroughly cleaned. Also, <strong>in</strong>spect to makesure that the <strong>in</strong>terior <strong>and</strong> exterior walls of the sludge separation area <strong>and</strong> the greaseseparation area are <strong>in</strong> operat<strong>in</strong>g condition.,The electrical portions of the <strong>separator</strong> as wellas the pumps should be <strong>in</strong>spected dur<strong>in</strong>g this time.• Before the <strong>separator</strong> is placed <strong>in</strong>to operation <strong>and</strong> at regular <strong>in</strong>tervals thereafter, the <strong>separator</strong>should be checked to make sure that it is water tight.• The <strong>in</strong>terior walls of the <strong>separator</strong>, as well as the exterior walls, should be cleaned <strong>and</strong>checked for damage every time the <strong>separator</strong> contents are disposed.• The <strong>separator</strong> should be <strong>in</strong>spected every 6 months. At this time the <strong>separator</strong> contents shouldbe disposed <strong>and</strong> the entire unit should be cleaned. Dur<strong>in</strong>g the clean<strong>in</strong>g check the sludge trap<strong>and</strong> grease separation portions of the <strong>separator</strong> to make sure they are <strong>in</strong> proper work<strong>in</strong>gcondition.• The electrical systems <strong>and</strong> the <strong>separator</strong>'s pumps should be <strong>in</strong>spected. The run-dry motorprotection sett<strong>in</strong>g is to be checked (see section 3.3 Electrical Installations of Chapter 3 -Installation of this manual.• It is recommended that a written log is kept for the <strong>separator</strong>. Documentation <strong>and</strong> <strong>in</strong>formationconern<strong>in</strong>g all disposals <strong>and</strong> any other work done to the <strong>separator</strong> should be kept <strong>in</strong> this log forfuture reference.Please make sure that:1. This Installation, Service <strong>and</strong> Ma<strong>in</strong>tenance Guide <strong>and</strong> any other documentation relat<strong>in</strong>g tothe <strong>separator</strong> is kept <strong>in</strong> a safe place accessible to all who work on the unit.2. Disposal of the contents of the <strong>separator</strong> follows the exact guidel<strong>in</strong>es stated <strong>in</strong> this guide.3. The disposal of the <strong>separator</strong> is carried out by a qualified, licensed company.11
Change language