to download user guide - NEXGEN Software Systems

Parameters‣ 01- Show historical Trades – if False speeds up loading – Set to TRUE tostudy the historical signals generated by the software.‣ 02- This will allow you to manipulate the live orders on the chart, entries ,stops , and targets.‣ 03- Set number of contracts for first profit target‣ 04- Set number of contracts for second profit target‣ 05 – This input sets a FIXED DOLLAR STOP – if the preset stops in theRevolution which are dynamic is risking LESS than your FIXED DOLLARSTOP then the lesser of the two amounts will be used by the system. IF set to“0” then only the Revolution stops will be used.‣ 06- Fixed Dollar Target – you can set this to any number. You will haveoptions later to take profit AT a fixed target or dynamic target or to engage atrailing stop once that target is hit.‣ 07- This setting allows you to adjust at what time the system will start takingtrades.‣ 08- This setting will allow you to adjust when the system will stop takingtrades.‣ 09- IF TRUE – The program will generate a limit order a number of ticksfrom the close of the “Signal Bar”. – 2 will be 2 ticks LOWER than close if along signal is generated , OR will be 2 ticks HIGHER if a short signal isgenerated. IF FALSE a market order will be used for entry.‣ 10- Number of ticks to offset a limit order entry.‣ 11- Number of “bars” the limit order has to get filled before the systemcancels the orders automatically.‣ 12- to allow reversals in position this must be set to true , it is false bydefault.‣ Ztemplate Save and Load are DEFAULTS TO PUSH INDICATORS TOCHARTS NO CHANGES WILL EVER BE NEEDED.39