RoadRunner Owner's Manual - Data I/O Corporation

Operation • Supervisor Functions •• Setting Operational ParametersSetting Operational ParametersSupervisorFunctionsWhile it is usually not necessary to change the system’s operational parameters,some of them may require adjustment when changing to a differentdevice package. All of them require setting after replacing the NVRAM batterysince this information is stored in Non-Volatile RAM. The Teach functionin the Operation menu contains the most often adjusted parameters. Thefollowing sections describe procedures for these four Teach parameters indetail. After that, common job parameters that can be customized are discussed.Operation > Teach > _________Tape:Used to teach the PNP head the positionof the tape pocket at the pick point.below3Skt 1:Used to teach the PNP head the positionof the first socket in the Socket Adapterboard.page 3-28Reject: Used to teach the PNP head the positionof the tab on the Reject Bin so thatrejected devices will slide into the bin.Belt: Used to teach the PNP head the positionof the place point on the output belt.page 3-28page 3-29Under some circumstances the keypad display may direct you to home thehead before setting the operation parameters.To home the head: From the top level menu, scroll to and select Home. Waitfor the head to stop moving.For details regarding step 1see “Loading Device Tape”on page 3-14 and “Aligningthe Device Tape—All Models”on page 3-17.For more help see “KeypadOperation” on page 3-4.Setting the “Tape” ParameterTo set the tape pocket position at the PNP pick point:1. Load and align the device tape. “See Loading Device Tape” and “AligningDevice Tape.”2. On the Keypad, press the Menu button until the top level menu is displayed.3. Scroll to and select Operation.4. Scroll to and select Teach.5. Scroll to and select Tape. The PNP head should move so probe #1 ispositioned over the device tape pick position.6. Use the Up Arrow or Down Arrow buttons to move the PNP head untilprobe #1 is perfectly centered over the hole in the center of the devicetape. Pushing probe #1 down by hand and holding it while making thisadjustment aids in judging when the probe is centered.7. Press the Menu button to record your setting and move up to the nexthigher menu.Data I/O • ProLINE-RoadRunner Owner’s Manual • 096-0240 [updated Mar2010] 3—27