RoadRunner Owner's Manual - Data I/O Corporation

Operation • Operator Functions •• Setting Up RoadRunner for a Programming JobOperator FunctionsFollow these steps to adjust the width of the Tape-In Module to accommodate44 mm tape width:1. With the E-Stop pushed, moved the PNP Head out of the way.2. Unscrew the Position Locking Screw most the way out using a 4 mmAllen wrench. See Figure 3-12.3Figure 3-12—XLF Models ONLY, have a 32/44 mm Tape-In Module. Thenotch currently indicates 32 mm. The Position Locking Screw is loosened.The 32 mm Front Track is not shown.3. Slide the Selector Plate so the notch points to 44 and tighten the LockingScrew.4. Remove the magnetic Front Track for 32 mm (if it is installed) by first,loosening the two Peel Bar screws.Peel Bar ScrewsPeel Bar32 mm Front TrackFigure 3-13—XLF Models ONLY, the 32 mm Front Track is installed.5. Lift the 32 mm track slightly to clear the locating pins and tip it back90° (away from you). Slide it out to the left.NOTE: For 32 mm device tape, install the Front Track in thereverse order as removal. Then slide the Selector Plate as describedabove so the notch points to 32.Data I/O • ProLINE-RoadRunner Owner’s Manual • 096-0240 [updated Mar2010] 3—13