RoadRunner Owner's Manual - Data I/O Corporation

Operation • Operator Functions •• Setting Up RoadRunner for a Programming JobOperator Functions1. With the power on and system ready (the blue light is the only light on),insert a job card.2. Using the control panel buttons, press the Menu button until the toplevel menu is displayed.3. Scroll to and select Job.4. Scroll to and select View.The list of hardware required for the job will be displayed.5. Scroll through the list of hardware settings. Verify that each of the followingjob-specific hardware pieces is installed on RoadRunner:3Device:Checksum:Mfg:Adapter:Prec:Act:Check this against the label on the reel of unprogrammeddevicesCheck that this is the unique job ID number youwish to run. Checksum represents either thechecksum of the device data, or the checksum ofthe device data plus extra bytes of storage for certaindevices. The checksum represents the data inits original endian (byte order) as of Version03.00.01.C.Check that the device manufacturer listed matchesthe actual device manufacturer.Check this against the label on the socket adapter.Check this against the (package-specific) numberetched on the precisor plate. Not required on XLF.Check this against the (package-specific) numberon the actuator.Also check that the Tape Advance module accommodates the appropriatewidth tape for the devices to be programmed.Make any changes necessary to comply with the data in the Control PanelDisplay.Don’t know whichTape-In Module youhave? Look at the imageson the next few page—theshape of the peel bar isdifferent for each model.Changing Tape Width on Adjustable Tape-In ModulesThere are three different adjustable Tape-In Modules. Adjustment of each isdescribed in the following headings.16/24/32 mm Tape-In Module (Standard Adjustable)If you use a 16/24/32 mm Adjustable Tape-In Module, follow these steps toadjust the width:1. Loosen the Position Locking Screw using a 4 mm Allen Wrench andthen rotate the 3-Position Spacer with your finger until you read 16, 24or 32, corresponding to your device tape width. Retighten the screw.3—10 Data I/O • ProLINE-RoadRunner Owner’s Manual • 096-0240 [updated Mar2010]