RoadRunner Owner's Manual - Data I/O Corporation

Installation • Mounting the RoadRunner •• Mounting RoadRunner [Panasonic CM401, CM402, DT]To mount RoadRunner onto the Panasonic Feeder Bank Adapter:1. Slide RoadRunner under the hook on the Feeder Bank Adapter so thatthe RoadRunner centering plate teeth engage the pin next to the hook.See Figure 2-17.2RoadRunner CenteringPlateFigure 2-17—The Panasonic Feeder Bank Adapter has a hook and a pin.2. Lower RoadRunner so that the Feeder Bank Adapter dowel mates withthe guide bushing on the RoadRunner conveyor. See Figure 2-18.Figure 2-18—The dowel on the Adapter (circled) mates with Roadrunner.3. Verify that RoadRunner is secure.To connect the Communication Cable into the HostFeeder:1. Correctly orient the connector (the red dot will be on top) and plug itinto RoadRunner. The socket is located on the back side—facing theSMT feeder table.2. Orient and plug the other end of the cable into the Host Feeder.3. Screw in the two connector screws. See Figure 2-19.Data I/O • ProLINE-RoadRunner Owner’s Manual • 096-0240 [updated Mar2010] 2—15