Operating Manual R&S SMIQ - Volume 1 - Rohde & Schwarz

SOURce:DM SubsystemSMIQ[:SOURce]:DM:DLISt:DATA? [ [,]]The command reads out the data list. If the query is enhanced by the two parameters start andlength, the list will be read out in smaller parts. Start and length are given in bits.Without parameters the whole length will always be output from address 1.The data format is selected by means of the :FORMat ASCii | PACKed command. The orderof the bytes is stipulated in the IEC/IEEE-bus standard (MSbyte first).Example: :SOUR:DM:DLIS:DATA? 2048,1024[:SOURce]:DM:DLISt:DATA:APPend 0 | 1 {,0 | 1 }...The command allows the data lists, which can be very long (up to 20 Mbits = 2.5 Mbyte), to betransmitted in smaller parts. They are added to the end of already existing data.First, the data list values have to be overwritten using the above DM:DLIS:DATA command.Further data can then be added using the DM:DLIS:DATA:APP commands. The data format isthe same for the two commands.Example: :SOUR:DM:DLIS:DATA:APP 0,1,1,0,0,0,0,0,1,0,1,1,0,1,0,0:SOUR:DM:DLIS:DATA:APP #12aX[:SOURce]:DM:DLISt:CATalog?The command returns a list of data list names separated by commas.Example: :SOUR:DM:DLIS:CAT?[:SOURce]:DM:DLISt:SELect ‘‘The command selects the indicated data list. This list will only take effect as data source withmode :DM:SOURce DLISt selected. The list can only be filled with values if it has been selectedbeforehand. If the indicated list does not exist, it will be generated. has to be put inbrackets (< >) and may have up to 8 characters.Example: :SOUR:DM:DLIS:SEL ’test’[:SOURce]:DM:DLISt:DELete ‘‘This command deletes the data list indicated by . The name has to be put in brackets ()and may have up to 8 alphanumeric characters. This command triggers an event and hence hasno *RST value and no query.Example: :SOUR:DM:DLIS:DEL ’test1’[:SOURce]:DM:DLISt:COPY ‘‘The command copies the selected list to the data list indicated by . This commandtriggers an event and hence has no *RST value and no query.Example: :SOUR:DM:DLIS:COPY ’test1’[:SOURce]:DM:DLISt:FREE?This command returns the available free space for digital data (in bits) and the length of theselected list. The 2 values are separated by a comma.Example: :SOUR:DM:DLIS:FREE?:SOURce]:DM:DLISt:POINts The command indicates the number of elements (in bits) of the currently selected data list. Sinceonly multiples of 8 bits can be transmitted when using block data, the exact number of used bitscan be set here. Overflow bits in the list are ignored.Example: :SOUR:DM:DLIS:POIN 2341125.5555.03 3.70E-9