Operating Manual R&S SMIQ - Volume 1 - Rohde & Schwarz

SMIQSOURce:DIST Subsystem3.5.14.4 SOURce:DIST SubsystemSubsystem DISTortion comprises all commands for setting the distortion simulator.The NDSim subsystem under CALibrate is available for the offset calibration.Command Parameter DefaultUnitRemark[:SOURce]:DISTortion[:STATe]:MODE:DATAON | OFFPOLYnomial | DATANot-SCPI:CATalog? name {,name}... Query only:SELect:DELete:ALL'name of characteristic''name of characteristic':AM -100 dB to 0 dB {, -100 dB to 0 dB } | block data dB:FREE?:POINts?:AMBase -100 dB to 0 dB {, -100 dB to 0 dB } | block data -:PM:POINts?:FREE?:POINts?-180 degrees to +180 degrees {, -180 degrees to+180 degrees} | block data:PMBase -100 dB to 0 dB {, -100 dB to 0 dB } | block data -:LEVel:POLYnomial:AMAM:AMPM:POINts?:CORRection -20.0 to 6.00 dB:K -10 dB to +10 dB dB:K:IFUNction:LEVel:RECalculate-60 deg to +60 degON | OFF:CORRection -20 dB to +6 dB dBdBQuery onlyQuery onlyQuery onlyQuery onlyQuery onlyQuery onlyNot-SCPI[:SOURce]:DISTortion[:STATe] ON | OFFThis command switches the distortion function on or off.Example: :SOUR:DIST ON *RST value is OFF[:SOURce]:DISTortion:MODE POLYnomial | DATADistortion data are calculated either by a list (:DIST:DATA... commands) or from the coefficientsof a polynomial (:DIST:POLY... commands).Example: :SOUR:DIST POLY *RST value is DATA[:SOURce]:DISTortion:DATAThe commands for the characteristics are under this node.1125.5555.03 3.61 E-9