Operating Manual R&S SMIQ - Volume 1 - Rohde & Schwarz

SMIQSOURce:DECT Subsystem[:SOURce]:DECT:SLOT:PRESetThe command sets all the following parameters of the slot to the values defined by the standardas a function of the type set above. This command triggers an event and hence has no *RSTvalue and no query.Example: :SOUR:DECT:SLOT2:PRES[:SOURce]:DECT:SLOT:STSHift -9 to +9 (in bit)This command allows a timing shift of the indicated slot by the set number of bits to simulate awrong timing (positive = delay; negative = advance).Example: :SOUR:DECT:SLOT2:STSH -3 *RST value is 0[:SOURce]:DECT:SLOT:RAMP:CW ON | OFFThe command activates or deactivates the generation of unmodulated (CW) signal during theramp time.Example: :SOUR:DECT:SLOT2:PRAM:CW ON *RST value is OFF[:SOURce]:DECT:SLOT:RAMP:DATA #B0 to #B111 to (12bit)The command sets the data used during the ramp time.Example: :SOUR:DECT:SLOT2:PRAM:DATA #B111100001111*RST value is 101010101010 / 010101010101 (downl./uplink)[:SOURce]:DECT:SLOT:PREamble:DATA #B0 to #B111 to (16bit)The command sets the data used for the 16-bit long preamble.Example: :SOUR:DECT:SLOT2:PRE:DATA #B1111000011110000*RST value is 1010101010101010 / 0101010101010101 (downlink/uplink)[:SOURce]:DECT:SLOT:PREamble:PROLonged:DATA #B0 to #B111 to (32bit)The command sets the data used for the 32-bit long preamble.Example: :SOUR:DECT:SLOT2:PRE:PROL:DATA #B1111*RST value 10101010101010101010101010101010 (downlink)*RST value 01010101010101010101010101010101 (uplink)[:SOURce]:DECT:SLOT:SYNC #B0 to #B111 to (16bit)The command sets the data used for synchronization.Example: :SOUR:DECT:SLOT2:SYNC #B0000111100001111RST value is 1110100110001010 / 0001011001110101 (downl./uplink)[:SOURce]:DECT:SLOT[:SOURce]:AFIeld PN9 | PN11 | PN15 | PN16 | PN20 | PN21 | PN23 |DLISt | SDATaThe command defines the data source for the A field. It is either a PRBS generator (of differentsequence length), a data list or the serial interface.Example: :SOUR:DECT:SLOT3:AFI PN15 *RST value is PN9[:SOURce]:DECT:SLOT[:SOURce]:AFIeld:DLISt ‘name’The command selects a data list. This list is used only if lists have been set as data source using thecommand :DECT:SLOT:AFI DLIS. This command triggers an event and hence has no *RST value.Example: :DECT:SLOT:AFI:DLIS ’test’1125.5555.03 3.59 E-9