Operating Manual R&S SMIQ - Volume 1 - Rohde & Schwarz

SMIQSOURce:DECT Subsystem[:SOURce]:DECT:PRAMp:DELay -1.0 to +1.0The command defines the shift of the envelope characteristic to the modulated signal. A positivevalue causes a delay of the envelope.Example: :SOUR:DECT:PRAM:DEL 0.2 *RST value is 0[:SOURce]:DECT:PRAMp:SHAPe LINear | COSineThe command selects the linear or cosine shape of the ramp-up and ramp-down (power burst).Example: :SOUR:DECT:PRAM:SHAP LIN *RST value is COS[:SOURce]:DECT:PRAMp:ROFFset -9 to +9The command determines the timing of the (‘R’ising) edge of a power burst to the beginning of theslot.Example: :SOUR:DECT:PRAM:ROFF -3 *RST value is 0[:SOURce]:DECT:PRAMp:FOFFset -9 to +9The command determines the timing of the ('F'alling) edge of a power burst to the data block.Example: :SOUR:DECT:PRAM:FOFF 4 *RST value is 0[:SOURce]:DECT:SLOT:ATTenuation 0 to 70 dBThe command determines the amount by which the power of the slots marked by:DECT:SLOT:LEVEL ATT is reduced in comparison with the normal output power (attribute to:LEVEL FULL).Example: :SOUR:DECT:SLOT:ATT 20 dB *RST value is 0[:SOURce]:DECT:SIMulation:TADJustment -4 to +4 (in symbols)This command simulates the timing adjust by extending every 35th frame by the set number ofsymbols (positive) or by reducing it (negative). 0 is off.Example: :SOUR:DECT:SIM:TADJ 3 *RST value is 0[:SOURce]:DECT:SIMulation:JITTer 0 to 4 (in symbols)This command simulates the jitter by advancing even frames by the set number of symbols andby delaying uneven frames. 0 is off.Example: :SOUR:DECT:SIM:JITT 2 *RST value is 0[:SOURce]:DECT:FLIStThe commands for storing and reading complete frames including their bursts (slots) are underthis node. Predefined and user-generated frames have to be distinguished.[:SOURce]:DECT:FLISt:PREDefined:CATalog?The command returns a list of all predefined frames.Example: :SOUR:DECT:FLIS:PRED:CAT?[:SOURce]:DECT:FLISt:PREDefined:LOAD ‘name’The command selects one of the predefined (fixed) frames (c.f. Chapter 2). This commandtriggers an event and hence has no *RST value.Example: :SOUR:DECT:FLIS:PRED:LOAD ’test’1125.5555.03 3.57 E-9