Operating Manual R&S SMIQ - Volume 1 - Rohde & Schwarz

SMIQDIAGnostic System:DIAGnostic:DLISt:CHECksum:CALculateThis command calculates the checksum of the currently selected control list (see DigitalModulation DLISt).Example: :DIAG:DLIS:CHEC:CALC:DIAGnostic:DLISt:CHECksum:DATA?This command displays the checksum calculated before in hexadecimal representation (seeabove).Example: :DIAG:DLIS:CHEC:DATA? Response:1234567:DIAGnostic:INFOThe commands which can be used to query all information which does not require hardwaremeasurement are under this node.:DIAGnostic:INFO:CCOuntThe commands which can be used to query all counters in the instrument are under this node(Cycle COunt).:DIAGnostic:INFO:CCOunt:ATTenuator 1 | 2 | 3 | 4 | 5 | 6?The command queries the number of switching processes of the different attenuator stages. Thestages are designated with Z1 to Z6 within the instrument. In this command they are differentiatedby a numeric suffix whose name corresponds to the number:Suffix Name Function1 Z1 40-dB stage2 Z2 20-dB stage3 Z3 5-dB stage4 Z4 20-dB stage5 Z5 10-dB stage6 Z6 40-dB stageExample: :DIAG:INFO:CCO:ATT1? Response: 1487:DIAGnostic:INFO:CCOunt:POWer?The command queries the number of switch-on processes.Example: :DIAG:INFO:CCO:POW? Response: 258:DIAGnostic:INFO:MODules?The command queries the modules existing in the instrument with their model andstate-of-modification numbers. The response supplied is a list in which the different entries areseparated by commas. The length of the list is variable and depends on the equipment of theinstrument. Each entry consists of three parts which are separated by means of blanks:1. Name of module; 2. Variant of module in the form VarXX (XX = 2 digits)3. Revision of module in the form RevXX (XX = 2 digits)Example :DIAG:INFO:MOD? Response: FRO Var01 Rev00, DSYN Var03 Rev12, to...1125.5555.03 3.41E-9