Operating Manual R&S SMIQ - Volume 1 - Rohde & Schwarz

SMIQSOURce:W3GPp-Subsystem[:SOURce]:W3GPp:COPYThe commands for copying the setting of a mobile or base station to the data record of another areunder this node. The :SOUR:W3GP:COPY:EXEC command starts copying.[:SOURce]:W3GPp:COPY:SOURce 1 to 4The command selects the station whose data are to be copied.Example: :SOUR:W3GP:COPY:SOUR 2[:SOURce]:W3GPp:COPY:DESTination 1 to 4The command selects the station to which data are to be copied.Example: :SOUR:W3GP:COPY:DEST 3[:SOURce]:W3GPp:COPY:COFFset 0 to 511The command sets the offset value for the channelization code in the target station. Thiscommand is only available under :SOUR:W3GP:LINK FORW/DOWN.Example: :SOUR:W3GP:COPY:SOFF 100[:SOURce]:W3GPp:COPY:EXECuteThe command starts copying.Example: :SOUR:W3GP:COPY:EXEC[:SOURce]:W3GPp:SEQuence AUTO | RETRigger | AAUTo | ARETriggerThe command selects the trigger mode for the W-CDMA sequence.AUTO Continuously repeatedRETRigger Continuously repeated; new start after a triggerAAUTo ARMED AUTO; waits for trigger, then switches over to AUTO and can no longer betriggeredARETrigger ARMED RETRIG; a trigger event is required to start, each new trigger causes a restartExample: :SOUR:W3GP:SEQ AAUT *RST value is RETR[:SOURce]:W3GPp:TRIGger:SOURce EXTernal | INTernalThe command selects the trigger source. With INT selected, triggering is via remote control usingthe trigger command or via EXECUTE TRIGGER in case of manual control.EXT The trigger signal is fed in via input TRIGININT A start is only possible manually or via the remote control command TRIG:DM:IMMExample: :SOUR:W3GP:TRIG:SOUR EXT *RST value is INT[:SOURce]:W3GPp:TRIGger:DELay 0 to 38399The command defines the trigger delay (in number of chips).Example: :SOUR:W3GP:TRIG:DEL 200 *RST value is 0[:SOURce]:W3GPp:TRIGger:INHibit 0 to 67108863The command sets the retrigger inhibit duration (in number of chips).Example: :SOUR:W3GP:TRIG:INH 1000 *RST value is 01125.5555.03 3.167 E-9