Operating Manual R&S SMIQ - Volume 1 - Rohde & Schwarz

SMIQSOURce:PDC Subsystem[:SOURce]:PDC:SLOT:SFRame:STATe ON | OFFThis command switches the superframe on or off. When switched on, RCD data will be insertedinstead of SACCH data in some slots and SYNC2 will be used instead of SYNC in the first slot ofthe superframe.Example: :SOUR:PDC:SLOT2:SFR:STAT ON *RST value is OFF[:SOURce]:PDC:SLOT:SFRame:RCHPosition 1 to 17The command determines the position of the second RCH.Example: :SOUR:PDC:SLOT2:SFR:RCHP 10 *RST value is 1[:SOURce]:PDC:SLOT[:SOURce]The commands for determining the source for the data contents are under this node. The sourceis either a PRBS generator (with different sequence length), the data input SER DATA or a datalist.Selection of data source for the data fields of the burst:PN9 to 23 PRBS generator has been selectedDLISt Data from a programmable data listSDATa Data from data input SER DATA[:SOURce]:PDC:SLOT[:SOURce]:DATA PN9 | PN11 | PN15 | PN16 | PN20 | PN21 | PN23 | DLISt |SDATaThe command determines the data source for the data words.Example: :SOUR:PDC:SLOT3:DATA PN15 *RST value is PN9[:SOURce]:PDC:SLOT[:SOURce]:DATA:DLISt ‘name’The command selects a data list. This list will not be used unless it is set as a data source bymeans of the :PDC:SLOT:DATA DLIS command. This command triggers an event and hencehas no *RST value.Example: :SOUR:PDC:SLOT:DATA:DLIS ’test’[:SOURce]:PDC:SLOT[:SOURce]:SACChannel PN9 | PN11 | PN15 | PN16 | PN20 | PN21 | PN23 |DLISt | SDATaThe command determines the data source for the slow associated control channel (for :SLOT:TYPETCH... and VOX).Example: :SOUR:PDC:SLOT3:SACC PN15 *RST value is PN9[:SOURce]:PDC:SLOT[:SOURce]:SACChannel:DLISt ‘name’The command selects a data list. This list will not be used unless it is set as a data source bymeans of the:SOUR::PDC:SOUR:SLOT:SACC DLIS command. This command triggers an eventand hence has no *RST value.Example: :SOUR:PDC:SLOT:SACC:DLIS ’test’[:SOURce]:PDC:SLOT[:SOURce]:RCHannel PN9 | PN11 | PN15 | PN16 | PN20 | PN21 | PN23 |DLISt | SDATaThe command determines the data source for the housekeeping channel (for:SLOT:FRAMe:STATe ON).Example: :SOUR:PDC:SLOT2:RCH DLIS *RST value is PN91125.5555.03 3.131 E-9