Operating Manual R&S SMIQ - Volume 1 - Rohde & Schwarz

SMIQSOURce:GPS Subsystem3.5.14.9 SOURce:GPS SubsystemThis subsystem contains the commands for simulating a GPS satellite.Command Parameter DefaultunitRemark[:SOURce]:GPS:STATeON | OFF:PRESet:STANdard:RF:SEQuence(without)(without)AUTO | RETRigger | AAUTo | ARETrigger | SINGle:TRIGger:SOURceINTernal | EXTernal:DELay 0 to 20 359 (chips):INHibit 0 to 67 108 863 (chips):OUTPut[1]|2:POLarityCODE | NBIT | NWORd | SFRame | FRAMePOSitive | NEGative:DELay 0 to 6 137 999 (chips):CURRent:FREQuency? Hz Query only:SRATe? (symb/s) Query only:DSHift -10kHz to 10kHz Hz:SRATe 500 000.0 to 1 500 000.0 (symb/s):CODE 1 to 37:DATAPATTern | DLISt:PATTern #B0 to #B1111111111111111, 1 to 16 1 to 16 bit:DLISt‘name‘:DLISt:CATalog? name, name... Query only[:SOURce]:GPS:STATe ON | OFFThe command switches the signal generation of a simulated GPS satellite on or off.Example: :SOUR:GPS:STAT ON. *RST value is OFF[:SOURce]:GPS:PRESet:STANdardThe command sets all the modulation parameters to the values of the GPS standard as with *RST(i.e., it does not set the parameters selected with the:GPS:PRES:RF command described below,the GPS triggers or the GPS-sequence parameter. This command triggers an event and hencehas no *RST value and no query.Example: :SOUR:GPS:PRES:STAN1125.5555.03 3.93 E-9