HX8218-C01 - All Shore Industries

HX8218-C01960CH TFT LCD Source Driver with TCON4. Pin descriptionDATA SHEET V04Pin name I/ODescriptionCLK I Clock signal. Latching data at the rising edge.D07~D00D17~D10D27~D20IHSIVSIIIDigital data input. DX0 is LSB and DX7 is MSB.1. If parallel RGB input mode is used, D0X, D1X, and D2X indicate R, G, andB data in turn.2. If serial RGB or CCIR601/656 input mode is selected, only D07~D00 areused, and others short to GND.Horizontal sync input in digital RGB mode. Or HREF input in CCIR601 mode.(Short to GND if not used)Vertical sync input in digital RGB mode. Or V123 input in CCIR601 mode.(Short to GND if not used)DEN I Input data enable control. Normally pull low.The shift direction of device internal shift register is controlled by this pin asLRCshown below:I LRC=H: STH OUT1 • • • OUT960 STHOLRC=L: STH OUT960 • • • OUT1 STHOPOL OPolarity select for the line inversion control signal.When POL=L, output voltage is negative polarity.When POL=H, output voltage is positive polarity.STB IStandby mode control. Normally pull high.When STB=L, source driver and DAC are off. All outputs are shorted to VSS.When STB=H, source driver and DAC are on.RESETB I Hardware global reset. Low active. Normally pull high.NPC ONTSC or PAL mode auto detection result.When NPC=H, NTSC mode is selected.When NPC=L, PAL mode is selected.UD IUp/down scan setting.When UD=H, reverse scan.When UD=L, normal scan.V1~V8 I Gamma correction voltage for DAC.VSETIF1, IF2CF1CF2MODZX1~3IIIIIIGamma correction voltage is set internally or externally. Normally pull high.VSET=L, internally.VSET=H, externally.Control the input data format.IF2, IF1Input data formatL, L (default) Serial RGBL, H Parallel RGBH, L CCIR601H, H CCIR656Define the input data sequence in serial RGB mode. Please referencesection5.5. Only effective when MOD=L. Normally pull low.Define the used delta type color filter. Please reference section5.5. Onlyeffective if MOD=L. Normally pull low.Define the color filter type. Normally pull low.When MOD=L, delta type.When MOD=H, stripe type.Zoom in/out modes setting pin. Zoom function is only active in CCIR601/656input mode. Normally pull high. Reference 5.7.Himax ConfidentialThis information contained herein is the exclusive property of Himax and shall not be distributed, reproduced, or disclosedin whole or in part without prior written permission of Himax. Subject to change without notice.-P.5-October 2006