Designio Frame PR0699 ENGIss5p1 - The Fire Basket

Designio FrameInstallation InstructionsFor use with Gas Riva 53, Gas or Electric Riva 67,16" VFC Convector, 22" VFC Convector,Logic Hotbox and Logic Convectorand Logic E-boxGazco Limited, Osprey Road, Sowton Industrial Estate, Exeter, Devon, EX2 7JGTel: 01392 261 999 Fax: 01392 444 148 E-mail: info@gazco.comA Member of the Stovax GroupPR0699 Issue 5 (September 2009)

INSTALLATION INSTRUCTIONSCovering the following frames8251GP 16" 8252GP 22" 8644GP Riva 53 8634GP Riva 678251IR 16" 8252IR 22" 8644IR Riva 53 8634IR Riva 67For use with Gas Riva 53, Gas or Electric Riva 67, 16"VFC Convector, 22" VFC Convector, Logic Hotbox,Logic Convector and Logic E-boxThese instructions are supplemental to, and must beread in conjunction with, the installation instructionssupplied with the fire. Read both thoroughly beforeinstalling the appliance.Fitting of this frame should be carried out after the firehas been installed but before any commissioning teststhat may be required.3912-396 E-box912-018 E-boxCassettes Balanced FlueINSTALLATION INSTRUCTIONS2.2 Take notice of the locating areas situated at the top of thefire ; these secure the back of the frame to the fire, seediagram 6.63.1 When the frame is fitted, the front door may be opened byplacing your hand at the lower right hand side and pullingforward. See diagram 8.83. OPENING THE DESIGNIO1. FITTINGNote: For fitting the Designio frame to a Riva 67 ConventionalFlue, please refer to Section 2.1.1 Take notice of the locating areas situated at the top of thefire as these secure the back of the frame to the fire. Seediagram 1.14Electric CassetteAR1192AR11902.3 Place the back of the frame over the locating areas andpush down to ensure rigid fixing.IMPORTANT: Ensure all three lugs have engaged, diagram 6.4. COMMISSIONINGAR12092.4 Open the door and secure the frame at the base using thetwo screws that were removed in Step 2.1.74.1 Continue with the commissioning tests detailed in theinstallation instructions supplied with the appliance.4.2 Ensure that this set of instructions is attached to theinstructions for the fire and leave with the user.5. CLEANING THE FRAME1.2 Place the back of the frame over the locating areas andpush down to ensure rigid fixing.Important: ensure all three lugs have engaged.See diagram 1.AR11901.3 Open the door and secure the frame at the base using thetwo screws as shown. See appropriate diagram.1.4 Check the magnet holds the door shut when in the closedposition.2. FITTING TO GAS RIVA 67CONVENTIONAL FLUEAR1184AR1192_25.1 Only clean the frame when it is cold.5.2 Do not use abrasive cleaners.5.3 Wipe with a damp cloth and buff with a clean, lint-freeduster.FIXING KIT COMPONENTSCOMP. No. DESCRIPTION QUANTITYPR0699 Instructions 12VFC/Logic2.1 Remove the two screws shown in diagram 5.5FA 0041 Spire Clip 2FA 0198No. 8 x 3/4 BlackWasher HD Pozi2AR1191AR172712